Spec Jay's BPv2 Street/Track Build

Elmo370z · 01-17-2021, 08:04 PM

Quote:

Originally Posted by Spooler

You need the Stillen front bumper so you can put your oil coolers outboard. It is not possible with the FI TT kit due to our intakes already being there.

I’ll make the existing bumper work. With the FI kit you can still make it work. Fab work isn’t a big deal with Brian

Spooler · 01-17-2021, 08:17 PM

Quote:

Originally Posted by Elmo370z

I’ll make the existing bumper work. With the FI kit you can still make it work. Fab work isn’t a big deal with Brian

If my car was a dedicated track car I would do something about it. I haven't had any issues at all doing what I do. I would like to have seen what the oil temps would have done at the Tail of the Dragon at Zdayz but they moved the event. I am not going to the new place. Plus, a turbo car doesn't need to be in the 7k rpm range to make power so you can use a lower gear to get it done.

Spooler · 01-17-2021, 08:26 PM

Quote:

Originally Posted by Elmo370z

I’ll make the existing bumper work. With the FI kit you can still make it work. Fab work isn’t a big deal with Brian

By the way, it was a challenge to get the brake ducts in. No way an oil cooler would fit. That is why Hotrodz has a 72 row oil cooler.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Installing the Spec Twin DisK Clutch Kit- Street Trim	Marti	Engine & Drivetrain	0	11-10-2014 02:13 PM
Track Vs. Street	chknhawk	Nissan 370Z General Discussions	31	03-20-2013 08:18 PM
Forged Performance: GT-R 4.0L FP1-R + FP Spec Stage 3 Trans Build	ChadB@Forged	Other Vehicles	1	02-23-2012 02:06 PM
Where can I go to see street cars on track?	Supragtsxr	Track / Autocross / Drifting / Dragstrip	8	08-22-2010 09:43 PM
ARK Performance INC. Track and Street Spec Coilovers Introduction	TeamARK	Suspension/Brakes	2	08-18-2010 01:50 PM