The New "What did you do with your Z today" (with off topic replies) X

happytheman · 01-20-2014, 12:27 PM

Quote:

Originally Posted by NissanFan

yikes...

Hahaha, I like Kenfan! I think it's gonna stick with me.

happytheman · 01-20-2014, 12:28 PM

I'm going through withdrawals. I'm thinking the only way to cure it would be to get a visit from the brown Santa.

NissanFan · 01-20-2014, 12:42 PM

Quote:

Originally Posted by happytheman

I'm going through withdrawals. I'm thinking the only way to cure it would be to get a visit from the brown Santa.

hey there, mr. happy. i like visiting amazon and brownsanta.

Quote:

Originally Posted by Pintsize725

I think they'll get here Thursday and install Saturday.

sounds

Quote:

Originally Posted by GaleForce

When tems are cold I bring the pillar paint and texture into the house for a day so they warm up. When I'm ready to paint I move my table in front of two 500Watt halogen lights. I turn them on for an hour and they heat up the table area nicely. Then i paint away. About an hour after the pillar has been sprayed and sitting under the lights I bring it back into the house four a couple of days. Then its good to go. No issues and the finish is as durable as when I do them in the summer.

Of course you don't need to do it right now as your Z is in storage mode.

thanks for the tip.

come to think of it, i do have two IR heatlamps i could use.

but yah, im just going to wait it out till it's warm enough.

NissanFan · 01-20-2014, 12:49 PM

did some promo for mspint's hate tread

Over 30 and still single, post here.

i miss posting there.

happytheman · 01-20-2014, 12:50 PM

Quote:

Originally Posted by NissanFan

hey there, mr. happy. i like visiting amazon and brownsanta.

hmmm, now what to buy?

WORK Gnosis CV202

Brush Silver Clear (BRU) Finish
Optional Anodized Polish Barrel (mirror polish)

(2) 19×9.5 +25 R-Disk (2.5″ lip) 5×114.3
(2) 19×10.5 +25 O-Disk (3.8″ lip) 5×114.3

Just curious what you thought of this configuration and what offset would get me a larger lip than this setup?

NissanFan · 01-20-2014, 12:54 PM

Quote:

Originally Posted by happytheman

hmmm, now what to buy?

WORK Gnosis CV202

Brush Silver Clear (BRU) Finish
Optional Anodized Polish Barrel (mirror polish)

(2) 19×9.5 +25 R-Disk (2.5″ lip) 5×114.3
(2) 19×10.5 +25 O-Disk (3.8″ lip) 5×114.3

Just curious what you thought of this configuration and what offset would get me a larger lip than this setup?

if your car's lowered the front should fit pretty snug, the rear will be sunken in a little. you can probably keep the front but the rear should be more like 19x10.5 ET12 or something to match the front. or get 19x11's ET15 maybe?

happytheman · 01-20-2014, 01:00 PM

Quote:

Originally Posted by NissanFan

if your car's lowered the front should fit pretty snug, the rear will be sunken in a little. you can probably keep the front but the rear should be more like 19x10.5 ET12 or something to match the front. or get 19x11's ET15 maybe?

I'm presently at stock height but plan on going with the swift (and possibly koni) setup eventually.

Pintsize725 · 01-20-2014, 01:15 PM

Mr. Kenchan, do you think I should change my sidewall size down to 45 if the new rims will be a bit more flush with the fender? I'm currently at 50.

Help me, tire/wheel guru!

NissanFan · 01-20-2014, 01:42 PM

Quote:

Originally Posted by happytheman

I'm presently at stock height but plan on going with the swift (and possibly koni) setup eventually.

the front will poke too much at stock height.

might want to do the swifts first, then get 19x9.5 ET25 and 19x11 ET15

(or your preferred offsets and sizes) custom order.

Quote:

Originally Posted by Pintsize725

Mr. Kenchan, do you think I should change my sidewall size down to 45 if the new rims will be a bit more flush with the fender? I'm currently at 50.

Help me, tire/wheel guru!

hummm... problem with going to a lower profile tire is that they usually end up more square than round on the shoulders. this can potentially make the wheel gap more pronunced.

wat were your forgestar sizes and offsets again?
wat are your stock tire sizes?

Pintsize725 · 01-20-2014, 01:49 PM

Quote:

Originally Posted by NissanFan

hummm... problem with going to a lower profile tire is that they usually end up more square than round on the shoulders. this can potentially make the wheel gap more pronunced.

wat were your forgestar sizes and offsets again?
wat are your stock tire sizes?

Fronts are 18x9 +30 and going with a 245-45 in the Pilot Super Sports.
Rears are 18x10 +16 and I'm going with a 265-40. << sales rep just said this isn't wide enough but everyone else has been telling me it is.

NissanFan · 01-20-2014, 02:16 PM

Quote:

Originally Posted by Pintsize725

Fronts are 18x9 +30 and going with a 245-45 in the Pilot Super Sports.
Rears are 18x10 +16 and I'm going with a 265-40. << sales rep just said this isn't wide enough but everyone else has been telling me it is.

wat are your stock tire sizes again? front and rear.

NissanFan · 01-20-2014, 02:24 PM

anyone know the stock base 18" tire sizes? front and rear?

i got the formula in front of me... need the numbers to punch in.

NissanFan · 01-20-2014, 02:29 PM

Pintsize725 · 01-20-2014, 02:29 PM

Quote:

Originally Posted by NissanFan

wat are your stock tire sizes again? front and rear.

Stock is 225/50 and 245/40

NissanFan · 01-20-2014, 02:35 PM

Quote:

Originally Posted by Pintsize725

Stock is 225/50 and 245/40

ok, so here's where you are stock vs new:

looking at this, you are already 2.25mm shorter sidewall than stock on the front, so you probably wont want to go any shorter than this as you will introduce more gap.

if you go 245/50 on the front, it will be too tall. so 245/45/18 on the front looks good.

01-20-2014, 12:28 PM	#2642 (permalink)
happytheman A True Z Fanatic Join Date: Apr 2010 Location: Florida Posts: 10,737 Drives: MB 6M Tour/Sport Z34 Rep Power: 1822	I'm going through withdrawals. I'm thinking the only way to cure it would be to get a visit from the brown Santa. Pintsize725 and NissanFan like this. __________________ --Brantly-- *PowderCoating by Mike/Stillen/PWJDM/Shine Auto/NST* GTR/Michelin /Fast Intentions/Evo-R/Mobil 1/Motul/Z1 https://facebook.com/CentralFloridaZClub

01-20-2014, 12:49 PM	#2644 (permalink)
NissanFan Enthusiast Member Join Date: Jul 2013 Location: OG Land Posts: 435 Drives: off topic to the max Rep Power: 29	did some promo for mspint's hate tread Over 30 and still single, post here. i miss posting there. Pintsize725 likes this. __________________ All photoshopped. Oh wait, where's all my car picts?

01-20-2014, 01:15 PM	#2648 (permalink)
Pintsize725 A True Z Fanatic Join Date: Jan 2012 Location: Austin Posts: 14,196 Drives: 2016 Mazda 6 Rep Power: 211844	Mr. Kenchan, do you think I should change my sidewall size down to 45 if the new rims will be a bit more flush with the fender? I'm currently at 50. Help me, tire/wheel guru! __________________ Tracie

01-20-2014, 02:24 PM	#2652 (permalink)
NissanFan Enthusiast Member Join Date: Jul 2013 Location: OG Land Posts: 435 Drives: off topic to the max Rep Power: 29	anyone know the stock base 18" tire sizes? front and rear? i got the formula in front of me... need the numbers to punch in. __________________ All photoshopped. Oh wait, where's all my car picts?

01-20-2014, 02:29 PM	#2653 (permalink)
NissanFan Enthusiast Member Join Date: Jul 2013 Location: OG Land Posts: 435 Drives: off topic to the max Rep Power: 29	__________________ All photoshopped. Oh wait, where's all my car picts?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The New "What did you do with your Z today" (with off topic replies) VIII	JARblue	The Lounge (Off Topic)	10016	11-10-2013 11:21 AM
The New "What did you do with your Z today" (with off topic replies) VII	Huck	The Lounge (Off Topic)	10072	09-26-2013 04:12 PM
The New "What did you do with your Z today" (with off topic replies) V	JARblue	The Lounge (Off Topic)	10002	05-29-2013 07:00 AM
The New "What did you do with your Z today" (with off topic replies) IV	happytheman	The Lounge (Off Topic)	10020	04-09-2013 11:47 AM
The New "What did you do with your Z today" (with off topic replies) II	happytheman	The Lounge (Off Topic)	10004	12-24-2012 07:31 PM