The New "What did you do with your Z today" (with off topic replies) XXIV

ChaseZ

I like them but if they were much more than the Kiwanis I'd still go that route myself.

madwi

I sent out for a quote, we will see. I actually dig the Work wheels a lot and they come in black.
Forgestar cf5v isnt too bad either and comes in a plethora of colors.
[IMG][/IMG]

kenchan

dose are pretty light weight too, no? thought forgestars are light?

madwi

They are not terrible if I remember correctly. I want to say they are heavier than factory though.

kenchan

i c... the RE11's are pretty heavy so something to think about.. going light on the wheels.

Leingod

So I am shopping around Amazon because Prime day ahs a special for Amazon Visa card holders. $30 off any prime purchase of $150. So I planned to buy a low-pro jack. But I found these things. I may order a pair and see if they'd allow enough room to allow my normal jack in the front and sides.

https://www.amazon.com/dp/B00UHLPES0...=IWWVZ8YYVE33P

__________________
I AM FLOOF! SOMEBODY FLOOF MY HORN!! ALL HAIL THE FLOOF!!I JUST FLOOFED ON THE FLOOR

kenchan

is ur car dat low where u cant get ur hydraulic under there?

Leingod

You are correct. I can't get my regular jack under the front or sides. This past oil change was a nightmare. I jacked from the diff in the rear. Got 1 stand under the rear side panel. Then lowered the car and jacked the other rear side panel. That gave me enough room to jack the front side panels while slowly sliding the stands since I only own 2.

So my original plan was to buy that pittsburg low pro steel jack. But now I am curious if I can spend half as much for some mini ramps allowing me to fit my standard hydraulic jack under the sides and front.

__________________
I AM FLOOF! SOMEBODY FLOOF MY HORN!! ALL HAIL THE FLOOF!!I JUST FLOOFED ON THE FLOOR

ChaseZ

Mine is too low for my low profile jack. Not least of all because the jack points are so far inbound on the car. I drive it on the a couple pieces of 2x4 then I can get it under. Had the same problem st the shop today to smoke it on the lift. Need 2x4 to get the arms of the loft underneath.

And I'm not exactly all that low either. Though I'm planning on raising it up about 3/8 all around but waiting until my spacers arrive on Friday to fit them first.

madwi

Save $40, a couple of 2x12's and you can have your own set.

Leingod

I don't have a circular saw nor know anybody close with one. I taught myself how to use power tools for as scary as that sounds.

__________________
I AM FLOOF! SOMEBODY FLOOF MY HORN!! ALL HAIL THE FLOOF!!I JUST FLOOFED ON THE FLOOR

kenchan

EXACTLY!!

dont waste ur money on that crap unless it has some faking cool logo or something on it