Suggestions for Velocity Stacks?

Jordo! · 05-16-2014, 03:11 AM

Quote:

Originally Posted by AzSpeng

Give me a length, the outside diameter of the largest part and outside diameter of the smaller part and ill draw something in cad and make a "prototype"

Awesome -- thanks!

Well, I'm not 100% sure on how to make the flange perfect, but something with at least three mounting locations would probably be good.

The inside diameter should be 2.25" and there appears to be enough room for a 3" bellmouth, ideally elliptical, with a rolled edge.

Length... I think we want to keep it close to the inlet -- too long might interfere with savaging from behind the stack, so, maybe 1.5" or 2" at the most in length?

Hell, if you are really serious and we can work something out to compensate your for your time, I'll just mail you the halved airboxes to work on.

AzSpeng · 05-16-2014, 10:10 AM

Give me a few hours to get things rolling in the shop and ill draw it up in cad.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Custom intake setup -- Stillen G3's, Velocity Stacks, Custom Front Crash Beam, pics	'10Anamoly	Intake/Exhaust	26	02-14-2015 10:59 AM
How the 370z stacks up: Dollar / Horsepower	osbornsm	Nissan 370Z General Discussions	21	09-12-2013 09:21 PM
Velocity MOD1 by UAM	Timothy@UAM	Body Interior/Exterior	72	10-20-2011 10:37 AM
Sugar Stacks	frost	The Lounge (Off Topic)	4	06-20-2009 10:00 PM

05-16-2014, 10:10 AM	#2 (permalink)
AzSpeng Enthusiast Member Join Date: Nov 2013 Location: Chandler, Az Posts: 345 Drives: Skyline GTR Rep Power: 13	Give me a few hours to get things rolling in the shop and ill draw it up in cad.