|
Originally Posted by AzSpeng Give me a length, the outside diameter of the largest part and outside diameter of the smaller part and ill draw something in cad and make
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-16-2014, 03:11 AM
|
#11 (permalink) | |
|
A True Z Fanatic
Join Date: May 2010
Location: nirvana
Posts: 6,394
Drives: 2023 NATM
Rep Power: 418   |
Quote:
Well, I'm not 100% sure on how to make the flange perfect, but something with at least three mounting locations would probably be good. The inside diameter should be 2.25" and there appears to be enough room for a 3" bellmouth, ideally elliptical, with a rolled edge. Length... I think we want to keep it close to the inlet -- too long might interfere with savaging from behind the stack, so, maybe 1.5" or 2" at the most in length? Hell, if you are really serious and we can work something out to compensate your for your time, I'll just mail you the halved airboxes to work on.
__________________
Enjoy it. Destroy it. |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Custom intake setup -- Stillen G3's, Velocity Stacks, Custom Front Crash Beam, pics | '10Anamoly | Intake/Exhaust | 26 | 02-14-2015 10:59 AM |
| How the 370z stacks up: Dollar / Horsepower | osbornsm | Nissan 370Z General Discussions | 21 | 09-12-2013 09:21 PM |
| Velocity MOD1 by UAM | Timothy@UAM | Body Interior/Exterior | 72 | 10-20-2011 10:37 AM |
| Sugar Stacks | frost | The Lounge (Off Topic) | 4 | 06-20-2009 10:00 PM |
21Likes
Threaded Mode
