Test Pipes + Tune = Pass Inspection (Texas)

jcosta79 · 05-04-2014, 12:31 AM

So I've had my lightly modded (K&N Typhoon, ARK test pipes & tune) Nismo for 2 years now and had to get my first state inspection. I had been told I would pass as long as I had a tune, but now I know for sure. :-)

I hope this helps some of you who are on the fence about getting test pipes.

Sent from my Nexus 7 using Tapatalk

DEpointfive0 · 05-04-2014, 12:36 AM

Preface this with: this only works in TX, because TX's inspection is a joke and is highly dependent on where you go to get it tested

jcosta79 · 05-04-2014, 12:39 AM

I did, I put Texas in the thread title. Each state does their own style of inspection.

Sent from my Nexus 7 using Tapatalk

synolimit · 05-04-2014, 02:33 AM

The tune doesn't matter. While idling or driving, a car will ALWAYS run 14.7 AFR. That's because it's in closed loop throttle. Only under WOT in open loop will you see AFR changes. What this actually means is if they did a sniffer test the car doesn't pollute over their EPA limits while at idle or while driving. Now if they didn't do a sniffer test then like ohio all they did was test the gas cap and check for check engine lights since check engine lights make cars run richer to protect then engine from damage. Richer obviously means lower than 14.7 AFR which is polluting more. Now if you had a huge fire breathing v8 and went catless and that engine was still idling at 14.7, it could fail since its feeding more cylinders and using more gas to idle therefore it could be over the EPA limits. Still don't know if you got sniffed but if you did its good to know a 3.7 v6 doesn't use that much gas in closed loop.

jcosta79 · 05-04-2014, 06:53 AM

Quote:

Originally Posted by synolimit

The tune doesn't matter. While idling or driving, a car will ALWAYS run 14.7 AFR. That's because it's in closed loop throttle. Only under WOT in open loop will you see AFR changes. What this actually means is if they did a sniffer test the car doesn't pollute over their EPA limits while at idle or while driving. Now if they didn't do a sniffer test then like ohio all they did was test the gas cap and check for check engine lights since check engine lights make cars run richer to protect then engine from damage. Richer obviously means lower than 14.7 AFR which is polluting more. Now if you had a huge fire breathing v8 and went catless and that engine was still idling at 14.7, it could fail since its feeding more cylinders and using more gas to idle therefore it could be over the EPA limits. Still don't know if you got sniffed but if you did its good to know a 3.7 v6 doesn't use that much gas in closed loop.

In Texas they plug into your OBD-II port and look for check engine lights and fault codes; they don't do a sniffer test. If you don't turn off the rear 02 sensors (which as far as I know can only be done via a tune), you will eventually get a CEL when running test pipes.

Sent from my Nexus 7 using Tapatalk

ANMVQ · 05-04-2014, 07:52 AM

So if you leave the rears off you'll fail, The ODB will be talking to your ECU and see those are in a "not ready" status. Guys here in MA( Which a Biach to get a sticker) have failed for shutting O2's off. Mostly the subi and EVO guys but :/

jcosta79 · 05-04-2014, 09:29 AM

Quote:

Originally Posted by ANMVQ

So if you leave the rears off you'll fail, The ODB will be talking to your ECU and see those are in a "not ready" status. Guys here in MA( Which a Biach to get a sticker) have failed for shutting O2's off. Mostly the subi and EVO guys but :/

I guess Texas doesn't look for that because mine are turned off and I passed.

Sent from my Nexus 7 using Tapatalk

big daddy · 05-04-2014, 10:03 AM

mine also passed in Texas with no issues.

Your right if you said it's a joke, it's all about the $$$$$$$$

RICAN · 05-04-2014, 10:20 AM

It depends where you go in tx because where I'm from (central tx) they don't even plug on obd2 readers and the inspection is only 14 dollars one time I did my inspection in Fort Worth and the charge me 34 and they put It on a dyno and everything and that was at a Jeffy lube

When i had my srt-4 I had strait pipe and catless downpipe and I always pass ...where I'm from the don't do emissions ...

synolimit · 05-04-2014, 02:20 PM

Quote:

Originally Posted by jcosta79

In Texas they plug into your OBD-II port and look for check engine lights and fault codes; they don't do a sniffer test. If you don't turn off the rear 02 sensors (which as far as I know can only be done via a tune), you will eventually get a CEL when running test pipes.

Sent from my Nexus 7 using Tapatalk

You are correct but if you're not tripping a code at the time you'll have no code. I go months and months without tripping a code.

synolimit · 05-04-2014, 02:25 PM

Quote:

Originally Posted by ANMVQ

So if you leave the rears off you'll fail, The ODB will be talking to your ECU and see those are in a "not ready" status. Guys here in MA( Which a Biach to get a sticker) have failed for shutting O2's off. Mostly the subi and EVO guys but :/

This isn't correct in why they fail. You're not shutting the rear o2 off, you're just shutting the cel off from turning on. I tune subis and no ones ever had an issue. If subis you know are failing something else is up.

mag_black · 05-04-2014, 10:37 PM

I passed MA inspection this saturday w/ ARTs and Uprev. All my monitors were in "ready state". I didn't turn off O2's or catalyst monitors. I do get p0420 if I drive it hard from "cat inefficiency" from time to time, but that goes away and doesn't cause any high idling.

05-04-2014, 12:31 AM	#1 (permalink)
jcosta79 A True Z Fanatic Join Date: Jul 2012 Location: N/A Posts: 1,430 Drives: N/A Rep Power: 14	Test Pipes + Tune = Pass Inspection (Texas) So I've had my lightly modded (K&N Typhoon, ARK test pipes & tune) Nismo for 2 years now and had to get my first state inspection. I had been told I would pass as long as I had a tune, but now I know for sure. :-) I hope this helps some of you who are on the fence about getting test pipes. Sent from my Nexus 7 using Tapatalk __________________ 2012 PW NISMO #0559 - GT Spec Brace Kit - Swift Springs - ARK TP & Invidia CBE K&N Intake - UpRev Tune - 15mm Z1 Spacers & Studs - StopTech Slotted Rotors & SS Lines - ZSpeed CMAK with Stage 2 Clutch and Lightweight Flywheel

05-04-2014, 12:36 AM	#2 (permalink)
DEpointfive0 Premium Member Bitches Join Date: Jan 2012 Location: SoCal Posts: 14,824 Drives: a lot Rep Power: 17151	Preface this with: this only works in TX, because TX's inspection is a joke and is highly dependent on where you go to get it tested megalapagas likes this. __________________ Do YOU want to know what/where I got my username from? ( Click to show/hide ) NSFW due to language:

05-04-2014, 12:39 AM	#3 (permalink)
jcosta79 A True Z Fanatic Join Date: Jul 2012 Location: N/A Posts: 1,430 Drives: N/A Rep Power: 14	I did, I put Texas in the thread title. Each state does their own style of inspection. Sent from my Nexus 7 using Tapatalk DEpointfive0 likes this. __________________ 2012 PW NISMO #0559 - GT Spec Brace Kit - Swift Springs - ARK TP & Invidia CBE K&N Intake - UpRev Tune - 15mm Z1 Spacers & Studs - StopTech Slotted Rotors & SS Lines - ZSpeed CMAK with Stage 2 Clutch and Lightweight Flywheel

05-04-2014, 02:33 AM	#4 (permalink)
synolimit A True Z Fanatic Join Date: May 2013 Location: Columbus, OH Posts: 5,051 Drives: 2013 Silver 370z Rep Power: 3388	The tune doesn't matter. While idling or driving, a car will ALWAYS run 14.7 AFR. That's because it's in closed loop throttle. Only under WOT in open loop will you see AFR changes. What this actually means is if they did a sniffer test the car doesn't pollute over their EPA limits while at idle or while driving. Now if they didn't do a sniffer test then like ohio all they did was test the gas cap and check for check engine lights since check engine lights make cars run richer to protect then engine from damage. Richer obviously means lower than 14.7 AFR which is polluting more. Now if you had a huge fire breathing v8 and went catless and that engine was still idling at 14.7, it could fail since its feeding more cylinders and using more gas to idle therefore it could be over the EPA limits. Still don't know if you got sniffed but if you did its good to know a 3.7 v6 doesn't use that much gas in closed loop. __________________ 13 370z- Last edited by synolimit; 05-04-2014 at 02:35 AM.

05-04-2014, 07:52 AM	#6 (permalink)
ANMVQ A True Z Fanatic Join Date: Mar 2011 Location: Framingham MA Posts: 2,732 Drives: 2014 Q50 AWD Rep Power: 19	So if you leave the rears off you'll fail, The ODB will be talking to your ECU and see those are in a "not ready" status. Guys here in MA( Which a Biach to get a sticker) have failed for shutting O2's off. Mostly the subi and EVO guys but :/ __________________ 14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

05-04-2014, 10:03 AM	#8 (permalink)
big daddy Enthusiast Member Join Date: Jan 2014 Location: San Antonio, Texas Posts: 290 Drives: 2013 Nismo Rep Power: 13	mine also passed in Texas with no issues. Your right if you said it's a joke, it's all about the $$$$$$$$ __________________ Fast intensions Non-Resonated Test Pipes and TDX CBE w/18" Resonators, Stillen Generation 3 Long Tube CAI, tint, tail light covers, Gramlights 57Xtremes, CS Nismo kit, and several carbon parts. Slowly getting more

05-04-2014, 10:20 AM	#9 (permalink)
RICAN Enthusiast Member Join Date: Jan 2013 Location: fort hood, tx Posts: 345 Drives: 2012 370z m6 Rep Power: 12	It depends where you go in tx because where I'm from (central tx) they don't even plug on obd2 readers and the inspection is only 14 dollars one time I did my inspection in Fort Worth and the charge me 34 and they put It on a dyno and everything and that was at a Jeffy lube When i had my srt-4 I had strait pipe and catless downpipe and I always pass ...where I'm from the don't do emissions ... Last edited by RICAN; 05-04-2014 at 10:24 AM.

05-04-2014, 10:37 PM	#12 (permalink)
mag_black A True Z Fanatic Join Date: Mar 2013 Location: Massachusetts Posts: 1,400 Drives: 09 370Z MT6 Rep Power: 666	I passed MA inspection this saturday w/ ARTs and Uprev. All my monitors were in "ready state". I didn't turn off O2's or catalyst monitors. I do get p0420 if I drive it hard from "cat inefficiency" from time to time, but that goes away and doesn't cause any high idling. __________________ fujimura ≠ abbeyRoadCompany ≠ fastIntentions ≠ motordyne ≠ avantGarde ≠ ecutek ≠ nismo ≠ stillen ≠ stoptech ≠ gtm ≠ spl ≠ carbonfiberelement ≠ stance™

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need to pass the emission inspection	dudesky	North East Region	9	05-22-2014 10:47 AM
Swapping Test Pipes and HFC re-tune?	Rupie	Intake/Exhaust	0	12-24-2012 10:15 AM
LTH and HKS where can i pass inspection in PA	Salem	Mid-Atlantic Region	9	12-10-2012 01:43 PM
K&N Typhoon + Megan Test Pipes + Tune	jcosta79	Intake/Exhaust	12	09-08-2012 10:18 PM
How to pass emmissions with test pipes?	babbagandu	Intake/Exhaust	9	10-07-2011 08:18 PM