Stripped demon bolt, need idea

Gauge

Tip: To avoid damage to engine parts while you are cranking I used a small piece of 2x4 to rest my tools on while torquing You may spend 5 bucks at a lowes or home depot to buy these. Plus they can be handy later to drive your car up unto

1. No definitely not. My driver side bolt snapped right off with just the impact socket. Start with 6 point impact sockets. Impact sockets are higher grade steel and won't warp as you put pressure on them.

To use extracter sockets you need to hammer it down on the bolt, then sort of rock it to make sure the teeth dig in good. You have to have as much pressure as possible while rocking. After a good amount of rocking and teeth digging you turn it ever so slightly, as many time as it will turn. Then rinse and repeat. Eventually the mother will snap.

Extractors sockets are not cheap. The impact socket kind that you want anyways. Regular ones are cheap as hell, but trust me, get impact.

2. There are 3 bolts to remove. From my research it appears the 2011 and 2012 models have 2 bolts facing towards the engine bay and one to the exhaust, but on 2010 and 2009 they have only one facing engine bay and two facing exhaust. It will be easy to tell. The demon bolts are on the outside corner of the triangle(the side closest to the fender). The second bolt facing engine bay (if you have one facing that direction) is more towards the engine itself. These bolts are harder to get to, but come off WAY more easily. It took barely any pressure at all to get mine off.

Once you reinstall I highly recommend leaving only the demon bolt hole facing the engine bay. Put the other two facing the exhaust. It is much easier to get these off from under the car and you will be happy you did it if you ever need to take them off again.

Hope this helps.

EDIT: Also repped you for using the search feature.

__________________
I am a demon bolt slayer.