03-28-2012, 10:26 AM
|
#11 (permalink)
|
|
Base Member
Join Date: Apr 2011
Location: Columbus, GA
Posts: 212
Drives: 2011 370z 7at GM
Rep Power: 16
|
Quote:
Originally Posted by mults
Last Thursday, I finally installed my Berk CBE and I must say the fit and sound are truly amazing. To me, it was the perfect choice. Now, I have a question or two. If you look at the attached photos, you'll notice that the tips protrude past the rear end by a little bit. In all of the photos that I have seen, the tips look like they are more flush, like the stock ones. Is it possible that the "y" pipe or resonators are installed upside-down? I don't think so, as the exhaust went on in about 1-1/2 hours (old one off and new one on by myself) and everything lined up perfectly. Is this a case of tolerances where mine is a little different. I don't really mind the look, but I am just comparing mine to what I have seen (only online, nothing in person) so I am curious. Has anyone else run into this?
Any help is appreciated.
|
Yup, mine is the same way. I had my berk and cnt installed a month ago and it does protrude more than all the pics on this thread.
__________________
Z1 Test Pipes, AAM S-Line Midpipe, Nismo Axleback, Takeda CAI, JDM fog light, Avant Garde M310 matte black, Tein springs, uprev 310whp-SOLD!
|
|
|
Similar Threads
11Likes
Threaded Mode
