Motordyne shockwave fitment

gshort24

OK thanks for confirming the end of your Y pipe is actually straight. If anyone recently installed their Shockwave exhaust please check and confirm.

They are from older posts, but all pictures I have seen seem to have the end of the Y pipe straight. It doesn't make any sense for any part on this exhaust to be angled downward on purpose while there is plenty of clearance on the top side of the pipe. The muffler is the low part of the exhaust so angling the tip of the Y pipe down so the muffler sits even lower is a crap design if its actually done on purpose now or unless they want even more people to have to buy overpriced replacement mufflers.

I called Motordyne when I received the exhaust and Motordyne told me the end of Y pipe is supposed to be angled down so people know that pointing down is the correct way to install the Y pipe. The way the flanges that connect to the test pipe/cat are rotated and welded in place determine which side of the Y pipe is up or down, you can only match up the holes on the flanges one way, so I think I was given a BS excuse. Motordyne already raised the price of this exhaust so it's one of the most expensive on the market, and claim we're supposed to be paying for the quality. I'm guessing they are so back ordered they are desperate to ship anything they can, and now they might not be honoring the warranty and admitting to a manufacturing defect of someone welded the end of the Y pipe on crooked.

I'll try reaching out to Motordyne again, and we'll see if they can prove new exhausts have the end of the Y pipe angled down on purpose or if they stand by their expensive products and admit I most likely have a manufacturing defect in which they will honor the warranty and send me a replacement Y pipe.