GTM TWIN TURBO install at HP Logic

Valentino

Good job Horsepower Logic.

Questions:

How is the rubber elbow holding @ 7.5psi(the one on the top left of the inter cooler)?

Would that rubber hoes take the heat and abuse of higher boost in the long run with out coming off or get damaged?

Thanks

westpak

well tough to tell since so far it has only been a few pulls on the dyno, but it held up fine with no obvious bulging, if that is your concern, it is pretty thick and as for heat, it wont see any more heat than the rest of the plastic/rubber parts in the engine bay.

it is similar if not the same as the parts used in the Injen cold air intakes.

__________________