|
Z&I: I had almost identical results with the Si and cogs (34T/30T) on my HR. Mine was making 450hp/375tq on a mustang dyno. It made 15 psi by 6700 RPMs
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
09-23-2014, 09:51 PM
|
#1 (permalink) |
|
Base Member
Join Date: Oct 2011
Location: NW Houston
Posts: 130
Drives: '08 350Z
Rep Power: 16  |
Z&I:
I had almost identical results with the Si and cogs (34T/30T) on my HR. Mine was making 450hp/375tq on a mustang dyno. It made 15 psi by 6700 RPMs and held 15 psi (belt slip) to redline. It broke a rod shortly after on the dyno. After building the motor, my next step was to either try to run a 34T/28T cog setup, or swap to the Ti trim. Then experiment with IAT sensor in Intake manifold, move MAFs, cut core support and install a larger filter as close as possible to the inlet.
__________________
Jtranbuilt '08 Z [Jtran PT7075 Single - Fujitsubo - Transgo - Wilwood - TE37SL - BC Racing] |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Just ordered my Stillen CBE | carmelvalleyZ | Intake/Exhaust | 12 | 03-23-2014 03:20 PM |
| Just ordered a 1LE | 280z/300zx | Other Vehicles | 4 | 08-18-2013 02:05 PM |
| Just ordered Stillen gen 3 cai | henryy370z | Intake/Exhaust | 3 | 08-02-2012 10:03 PM |
| just ordered! | nj2alaska | New 370Z Owner | 9 | 07-21-2011 04:18 AM |
| Stillen CBE and Berk HFC ordered | Nitex | Intake/Exhaust | 19 | 02-07-2010 08:45 AM |
180Likes
Hybrid Mode
