GT Motorsports: 370Z Supercharger system development

SAM@GTM · 09-20-2009, 01:04 AM

Quote:

Originally Posted by john370z

I know I have a question and I am guessing many others are also interested in the answer as well. I would love to have a forced induction system (especially since I am at 5500 ft. elevation and am already loosing over 20% from that alone) but to use Ron Popeil’s term, I would like to “set it and forget it”. I would like the highest gains that are safe for the engine. I would not like to have the lifespan of the engine reduced by any significant amount. I do not want to have to take it to a tuner after the initial setup and install and initial tune. Basically I would like the overall reliability to remain while performance was greatly improved. Is this possible? Am I expecting too much? If I wanted 375+ rwhp, should I have bought a car that came that way from the factory? I would love to hear from GTM and Stillen about these questions. Thanks for your time and attention!
John

John

I don't think you are expecting too much, That is the way it should be and that is why we offer our GTM turn key so you can "set it and forget it " as you said .

-Our GTM Turn key solution whether TT or SC does not require a retune (maf tuning )

-Our engine management solution is done via flashing the factory ecu so basically you are getting the factory driveability just with a lot more power

Plus We are working on a good platform from the start, all those things will deliver what you are looking for and more ...All you have to do is just buy the GTM kit

Sam

john370z · 09-20-2009, 01:56 PM

thanks sam!

NewYorkJon34 · 09-20-2009, 03:30 PM

How much TQ did your kit dyno at?

john370z · 09-20-2009, 09:01 PM

Yes...would love to know the s/c torque curve...compared to the TT setup?

jmlenz · 09-21-2009, 12:54 AM

^ dont think the SC kit is up and running yet...still a ways off from dyno numbers for sure

RCZ · 09-21-2009, 10:22 AM

They are probably fabbing the piping as we speak...

SAM@GTM · 09-21-2009, 08:19 PM

Quote:

Originally Posted by RCZ

They are probably fabbing the piping as we speak...

We will have some more pics to show by the end of this week, It is moving forward smoothly .

Sam

NewYorkJon34 · 09-21-2009, 08:40 PM

How are you guys going to handle the tuning for the S/C?, since the VVEL is such a pain in the ***.

LiquidZ · 09-21-2009, 08:43 PM

Quote:

Originally Posted by NewYorkJon34

How are you guys going to handle the tuning for the S/C?, since the VVEL is such a pain in the ***.

Probably the same way they did with their TT kit

nogoodname · 09-21-2009, 08:44 PM

software and hardware included on the TT kits i heard

NewYorkJon34 · 09-21-2009, 08:46 PM

I might have to check that thread, I'm not interested in a turbo kit so I don't really check that thread often.

nogoodname · 09-21-2009, 08:49 PM

i dont see why it wouldnt be available on this kit

LiquidZ · 09-21-2009, 08:49 PM

Quote:

Originally Posted by NewYorkJon34

I might have to check that thread, I'm not interested in a turbo kit so I don't really check that thread often.

I think GTM will flash your ECU with a preliminary version of UpRev. I'm sure you can find the answer you are looking for in the TT thread.

NewYorkJon34 · 09-21-2009, 08:53 PM

Anybody wanna take a guess how much Torque this kit could make?

SAM@GTM · 09-21-2009, 09:25 PM

Quote:

Originally Posted by NewYorkJon34

How are you guys going to handle the tuning for the S/C?, since the VVEL is such a pain in the ***.

We Tune the ecu via flash, The VVEL is not that big of deal to control, its more then a pain in *** and almost mission impossible if you are trying to use a piggyback like stillen . The key is to have full control over the ecu which we do

Sam

09-20-2009, 01:56 PM	#152 (permalink)
john370z Base Member Join Date: Jan 2009 Location: new mexico Posts: 141 Drives: 2007 335i coupe Rep Power: 284	thanks sam! __________________ 2009 370Z, Had Berk HFC and un-installed them cuz too noisy!, Stillen CBE, 10mm rear wheel spacer, K&N drop in filters. Blower to come...

09-20-2009, 09:01 PM	#154 (permalink)
john370z Base Member Join Date: Jan 2009 Location: new mexico Posts: 141 Drives: 2007 335i coupe Rep Power: 284	Yes...would love to know the s/c torque curve...compared to the TT setup? __________________ 2009 370Z, Had Berk HFC and un-installed them cuz too noisy!, Stillen CBE, 10mm rear wheel spacer, K&N drop in filters. Blower to come...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Official 370Z 1/4 mile Times thread (Stock, TT, Nitrous, Supercharger, Bolt ons etc)	AK370Z	Track / Autocross / Drifting / Dragstrip	618	08-16-2019 12:56 PM
GT Motorsports: 370Z Stock block testing, and turbo system development	George@GTM	Forced Induction	314	07-26-2012 08:58 AM
Vortech Supercharger Development	Minicobra1	Forced Induction	124	02-02-2010 03:59 AM
GT Motorsports 2.5" True Dual Cat-Back Exhaust system.	George@GTM	Drivetrain/Engine	24	04-27-2009 06:32 AM

09-20-2009, 03:30 PM	#153 (permalink)
NewYorkJon34 A True Z Fanatic Join Date: Jun 2009 Location: Naples, Florida Posts: 3,041 Drives: 09 Fairlady Z Rep Power: 1065	How much TQ did your kit dyno at?

09-21-2009, 12:54 AM	#155 (permalink)
jmlenz Track Member Join Date: May 2009 Location: San Diego Posts: 645 Drives: a car Rep Power: 644	^ dont think the SC kit is up and running yet...still a ways off from dyno numbers for sure

09-21-2009, 10:22 AM	#156 (permalink)
RCZ A True Z Fanatic Join Date: Nov 2008 Location: Miami Posts: 6,403 Drives: '09 370Z Rep Power: 1119	They are probably fabbing the piping as we speak...

09-21-2009, 08:40 PM	#158 (permalink)
NewYorkJon34 A True Z Fanatic Join Date: Jun 2009 Location: Naples, Florida Posts: 3,041 Drives: 09 Fairlady Z Rep Power: 1065	How are you guys going to handle the tuning for the S/C?, since the VVEL is such a pain in the ***.

09-21-2009, 08:44 PM	#160 (permalink)
nogoodname Lifetime Premium Join Date: Nov 2008 Location: Montreal Posts: 22,357 Drives: E46 M3 Rep Power: 1765	software and hardware included on the TT kits i heard

09-21-2009, 08:46 PM	#161 (permalink)
NewYorkJon34 A True Z Fanatic Join Date: Jun 2009 Location: Naples, Florida Posts: 3,041 Drives: 09 Fairlady Z Rep Power: 1065	I might have to check that thread, I'm not interested in a turbo kit so I don't really check that thread often.

09-21-2009, 08:49 PM	#162 (permalink)
nogoodname Lifetime Premium Join Date: Nov 2008 Location: Montreal Posts: 22,357 Drives: E46 M3 Rep Power: 1765	i dont see why it wouldnt be available on this kit

09-21-2009, 08:53 PM	#164 (permalink)
NewYorkJon34 A True Z Fanatic Join Date: Jun 2009 Location: Naples, Florida Posts: 3,041 Drives: 09 Fairlady Z Rep Power: 1065	Anybody wanna take a guess how much Torque this kit could make?