|
That's nuts on a stock block haha. I have my MBC set to about 8-9 PSI, and on a daily basis my engine hardly sees 5 PSI (half throttle). Only
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-30-2012, 09:21 AM
|
#11 (permalink) |
|
A True Z Fanatic
Join Date: Jan 2009
Location: Kansas
Posts: 3,800
Drives: 09 Z34-TT 6MT
Rep Power: 44   |
That's nuts on a stock block haha. I have my MBC set to about 8-9 PSI, and on a daily basis my engine hardly sees 5 PSI (half throttle). Only times I have the need to max it out is for a few spirited tests or showing off to my friends with a test drive.
I'm more worried about spinning the bearings than snapping a rod. [shrugs] I definitely won't bore the block, but to hone it and possibly run 96 mm pistons. That's it. Are the pins treated or coated in any fashion? OK, I probably don't see the need for GTX turbos then. I wouldn't mind getting new/updated internals before re-installing, though. 
__________________
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine Build | esfourteen | Forced Induction | 190 | 07-26-2014 09:55 PM |
| engine build time | Nissan370 | Forced Induction | 42 | 08-05-2012 09:48 AM |
| UAM Customers Build Thread. | Jamaica | Forced Induction | 90 | 04-19-2012 10:24 PM |
| THE "Lets argue about Bullitt's build with out ruining Bullitt's build thread" THREAD | Reaper42 | Forced Induction | 14 | 01-22-2011 05:24 PM |
| Offical build your Z34 thread | cstr_Cali | Nissan 370Z General Discussions | 68 | 07-16-2009 07:01 PM |
34Likes
Threaded Mode
