|
when round orings go square with frayed edges it is almost a sure sign of to thick of a ring or too shallaw of a groove, o-rings need only have
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
07-03-2014, 11:41 AM
|
#11 (permalink) |
|
A True Z Fanatic
Join Date: Aug 2009
Location: In the D
Posts: 3,732
Drives: v8 74 260z ;)
Rep Power: 7251   |
when round orings go square with frayed edges it is almost a sure sign of to thick of a ring or too shallaw of a groove, o-rings need only have 10-20% compression on a face seal so if it were a 2.0mm oring it needs a groove that is 1.7mm deep. Since it is a low pressure application it really need be only 10% if it were for the oil system then i would say 20-25%
__________________
ANSWER PRICE LIST Answers - - - - - - - - - - - - - - - - $0.75 Answers (requiring thought) - - - - $1.25 Answers (correct) - - - - - - - - - - $12.50 Last edited by 1slow370; 07-03-2014 at 11:43 AM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GT Motorsports: 370Z Supercharger system development | SAM@GTM | Forced Induction | 1396 | 02-02-2014 10:54 PM |
| STILLEN 370Z Dual Exhaust System w/pricing | AK370Z | STILLEN | 25 | 01-03-2011 07:49 PM |
| Preparation for the STILLEN supercharger | Kyle@STILLEN | Forced Induction | 1087 | 03-13-2010 05:59 AM |
| Stillen Supercharger estimates??? | NewYorkJon34 | Forced Induction | 454 | 01-22-2010 11:05 PM |
| Will Stillen Supercharger & G3 intakes Connect? | NewYorkJon34 | Forced Induction | 23 | 10-31-2009 12:09 AM |
44Likes
Threaded Mode
