Announcing TopgunZ ACE Supercharger Kit!

DrBacon · 09-22-2021, 01:13 AM

So some updates on that intake: Unfortunately it didn't really work out, while the fabricator did about as good of a job as one could do with that hilariously limited space and offset there just wasn't enough airflow, car maxed out at 9psi (for comparison I did 15psi with that K&N filter and a little over 17psi with a turboguard). Because it was hand made it was shaped similar to a box which is going to be pretty rough on the airflow since it would have to make a couple 90 degree turns. I'm assuming it could probably work if a similar piece was cnc machined or used some high temp 3d printed plastic to create smooth angles instead but I have no way of doing that.

I have not given up however, I have a couple other ideas I plan on trying out later this week/next week instead.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Topgunz full supercharger kits!!	TopgunZ	Forced Induction	497	02-10-2020 05:23 AM
[FOR SALE] Stillen/Topgunz A2A Supercharger Partout	fork	Parts for sale (Private Classifieds)	18	12-04-2019 06:52 AM
[WTB] Supercharger kit Stillen, TopGunz, etc	NismoJohnG	Parts for sale (Private Classifieds)	5	05-06-2019 09:08 AM
Topgunz a2a and full supercharger cyber sale!	TopgunZ	Drivetrain/Engine	0	11-26-2018 12:38 PM
[FOR SALE] Topgunz a2a and full supercharger sale!	TopgunZ	Parts for sale (Private Classifieds)	0	11-26-2018 12:37 PM

09-22-2021, 01:13 AM	#1 (permalink)
DrBacon Enthusiast Member Join Date: Nov 2016 Location: Washington Posts: 286 Drives: 2014 Nismo Rep Power: 27366	So some updates on that intake: Unfortunately it didn't really work out, while the fabricator did about as good of a job as one could do with that hilariously limited space and offset there just wasn't enough airflow, car maxed out at 9psi (for comparison I did 15psi with that K&N filter and a little over 17psi with a turboguard). Because it was hand made it was shaped similar to a box which is going to be pretty rough on the airflow since it would have to make a couple 90 degree turns. I'm assuming it could probably work if a similar piece was cnc machined or used some high temp 3d printed plastic to create smooth angles instead but I have no way of doing that. I have not given up however, I have a couple other ideas I plan on trying out later this week/next week instead.