I dropped Seb an email but they are out until after first of the year.
I don't expect a reply until next year.

I was close, mine actually had the digital temp readouts but they were cheap. Looked like an old cheap ironing board cover that someone left a hot iron on after that incident.

Seb got back with me. He used the CJ Motorsports fitting for the PVC valves with their normal kit. I am assuming 2 of them. Can you take a picture of yours, I would like to see how they were mounted.

Will do...it may be a minute because the car is at the shop for safety and aero up grades!

Sent from my SM-G965U using Tapatalk

No rush.....

Well, today really has freaking sucked. I just got added to the long list of folks in the Blown Headgasket club. She's done. It is not a matter of IF you are going to blow the headgaskets, it is a matter of when. Not a happy camper. Blew at 17psi of boost. I rarely ran 22psi. Only 6 or 7 times. No way the car will make it to Zdayz 2020.

Welp, that sucks :(

Boo. Sorry to hear that!

Sent from my SM-G955U using Tapatalk

Oh no and I am next jump in the game of Russian Roulette!

Sent from my SM-G965U using Tapatalk

It blew in glorious fashion getting on the interstate. 3rd gear, 17 psi of boost, having fun. Then a front windshield full of coolant. It blew the bottom radiator hose off the motor. The fire ring in the head gasket is done. No coolant in the oil. Just compression leaking into the blocks water jackets. May have more damage, won't know until the heads come off. I made it 7xxx miles and then the big oh shiet moment. Not even an hint of a problem, just BOOM!!!!!

Were you running L19 head studs? After Seb was freaking me out over head lift I did some reading and it's not a code red situation, more of a flashing yellow alert with no bells. Some of what I read was replacing whatever gasket with an HKS gasket and retorquing. I haven't had it yet and had that 27.8psi spike at Wannagofast but if it does happen I've rethought L19s and I'll go with a 625 setup. Good luck buddy.

That's a Christmas present that one wants. :shakes head:

When you take the heads off. Check the torque on the head bolts. Just curiosity. And if you knew what the length of the head studs was too.

I told you I got Switches and Coal..... I wasn't lying.

Noop...

I will leave that for the machine shop to compare their notes too. Won't do me any good if I get in there and start pulling it down. It has crossed my mind though.