Gtm sc install

jmroy6 · 10-20-2017, 08:30 AM

I did exactly that, i guess i didn't have enough pressure on the reservoir side cause i never saw fluid pour out the banjo bolt. So i just hooked up my vacuum bleeder to the outlet hose on the blower and sucked all the air out until fluid came through. All is well, i just got a little worried i ****** something up.

Quote:

Originally Posted by kentmo280z

Are you priming it by blowing compressed air into the system, with the top of the reservoir banjo bolt un hooked? Then shooting compressed air (8lbs) into the sealed off resv. opening. I used a synthetic cork to seal the opening and ran my air gun extension through the cork. Fluid should come through the banjo bolt after a few minutes. Arrow on the filter points toward the rear of the car.
Also the line out of the filter MUST go into the inlet of the SC housing!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sts install	usaygo	Forced Induction	8	04-10-2015 09:57 AM
Sub Box install	Tokugawa	Nissan 370Z Roadster (Convertible)	1	01-06-2015 11:44 AM
K&N Install HELP with re-set!	TexasChuck	Intake/Exhaust	2	10-06-2013 11:34 AM
Install my own GTM kit?	MattP725	Forced Induction	31	10-17-2011 08:17 AM
Need some help for install	V8Killer	DIY Section (Do-It-Yourself)	3	08-12-2011 06:56 PM