928 Motorsports ceramic bearing installation

Max abbas · 10-11-2017, 11:39 PM

I did my own rebuild using 928 HS bearings kit
you do need a press and a pulley and bearing puller
they will need to press out the output shaft to release the assembly from the housing, will have to pull the bearings out and press back in, once bearings are all in place, take caution with returning the input/output shaft as they tempt to rotate because of the helical gears.
use these instructions for guidance
http://www.starrland.com/supercharge...%202-22-08.pdf

things to look out for:
make sure u place all the washers in their locations.
be careful pulling the input shaft in attempt to separate from output shaft as the bearing will bend the oil slinger.
when pressing the impeller back on, make sure u don't press it too far causing the seal to bulge which will leak air pressure in causing the blower to shoot oil out the vent gap.

the link provided has some revisions at the bottom.
read through the instructions multiple times, understand them and read them again (or have the shop read over them)

good luck

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Z1 Motorsports JDM Fog Light Light Installation Kit (Starting @ $18.00 w/ out Light)	Dustin@Z1	Body Interior/Exterior	4	11-04-2016 05:16 AM
Spun bearing – help	wdkwang	Engine & Drivetrain	5	07-27-2016 10:15 AM
Hub&Bearing	dimitarm	Wheels & Tires	0	08-16-2013 12:35 PM
Throughout Bearing?	Rooskey	Engine & Drivetrain	10	03-23-2011 07:37 PM
Z1 Motorsports Reverse Fog Light Installation Harness Now Available!	Dustin@Z1	Z1 Motorsports	1	12-08-2010 06:17 PM

10-11-2017, 11:39 PM	#5 (permalink)
Max abbas Base Member Join Date: Oct 2014 Location: Philadelphia Posts: 6 Drives: 04 nissan 350z Rep Power: 12	I did my own rebuild using 928 HS bearings kit you do need a press and a pulley and bearing puller they will need to press out the output shaft to release the assembly from the housing, will have to pull the bearings out and press back in, once bearings are all in place, take caution with returning the input/output shaft as they tempt to rotate because of the helical gears. use these instructions for guidance http://www.starrland.com/supercharge...%202-22-08.pdf things to look out for: make sure u place all the washers in their locations. be careful pulling the input shaft in attempt to separate from output shaft as the bearing will bend the oil slinger. when pressing the impeller back on, make sure u don't press it too far causing the seal to bulge which will leak air pressure in causing the blower to shoot oil out the vent gap. the link provided has some revisions at the bottom. read through the instructions multiple times, understand them and read them again (or have the shop read over them) good luck