Idle surge after Stillen supercharger install

NissanTracker · 06-07-2018, 08:35 AM

Well, I lost faith in all shops in this area for sure.

I just picked up my Z with such a horrible experience from this shop. The entire time, they said the car was done. I go to pick up, car does not rev past 2K RPMs. Just bounces after 2.1K. Idle is even WORSE... to the point where it wants to die. Apparently there was a lot of frustration there before I got there. The brother of the tuner got into a heated conversation with my old man and I because i was not satisfied. Drove the car not more than 1 mile... had to tow it home. Anythin past 2.1K rpms, the needle would just started bounces all over the place.

***SIGH****

I am going to contact UpRev and tell them my experience. This shop is listed on their web page. If you want to avoid this shop in the future, send me a PM and I'll give you the name of it.

I'm considering an E-Tune... Any takers?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Idle pulley for my Stillen SC install	wideglideleon	Forced Induction	2	06-26-2017 06:21 PM
Stillen Supercharger Install (2010 Nissan 370Z)	Nik@SOHO	Forced Induction	18	05-29-2017 09:30 PM
Stillen Supercharger post-install issues	WillVHR	Forced Induction	6	01-29-2016 07:49 PM
Stillen Supercharger Froozen Boost Intercooler Install	EVOHUNTER	DIY Section (Do-It-Yourself)	0	05-16-2015 11:01 AM
Starting problem after stillen supercharger install	fastlandyacht	Forced Induction	5	08-27-2012 02:57 PM

06-07-2018, 08:35 AM	#1 (permalink)
NissanTracker Track Member Join Date: Jun 2016 Location: Massachusetts Posts: 725 Drives: 07' Nismo, 14' Nismo Rep Power: 29263	Well, I lost faith in all shops in this area for sure. I just picked up my Z with such a horrible experience from this shop. The entire time, they said the car was done. I go to pick up, car does not rev past 2K RPMs. Just bounces after 2.1K. Idle is even WORSE... to the point where it wants to die. Apparently there was a lot of frustration there before I got there. The brother of the tuner got into a heated conversation with my old man and I because i was not satisfied. Drove the car not more than 1 mile... had to tow it home. Anythin past 2.1K rpms, the needle would just started bounces all over the place. *SIGH** I am going to contact UpRev and tell them my experience. This shop is listed on their web page. If you want to avoid this shop in the future, send me a PM and I'll give you the name of it. I'm considering an E-Tune... Any takers?