BP turbo build/advice

solidus · 05-17-2017, 11:34 AM

Quote:

Originally Posted by hc_416

The belief is the slnoid is bad on the bc; going to switch to a different unit at some point. I am just gonna enjoy the car on the 16 psi spring for now. Now I just have to wait for my intake mani and will slap it on. After that a tune for aam!!

They told me my solenoid was probably bad too because it kept spiking on the dyno but it turned out that it was the hole in the vaccum line for the upper passenger side wastegate. Even after it took a poop the hole was still tiny but still enough that it prevented the wastegate on that side from doing it's job.

hc_416 · 05-17-2017, 09:58 PM

Quote:

Originally Posted by solidus

They told me my solenoid was probably bad too because it kept spiking on the dyno but it turned out that it was the hole in the vaccum line for the upper passenger side wastegate. Even after it took a poop the hole was still tiny but still enough that it prevented the wastegate on that side from doing it's job.

That is what i think it is, I went right to the waste-gate spring and it work's fine, I still need to get it tested out to see if it is or not.

solidus · 05-18-2017, 07:40 AM

Quote:

Originally Posted by hc_416

That is what i think it is, I went right to the waste-gate spring and it work's fine, I still need to get it tested out to see if it is or not.

If you do , order some heat sleeve for all the lines that run near hot areas.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbo Build	davidson_z34	Forced Induction	33	11-12-2015 07:45 PM
Need Advice on Bottom End Build	604GZ	Engine & Drivetrain	5	04-07-2015 09:09 AM
Single turbo build	jlask370	Forced Induction	13	10-07-2013 12:41 PM
Need advice on stereo build....	mengel	Audio & Video	7	02-08-2011 08:24 AM