8-Rib High-Traction Supercharger Pulleys

TBatt

Cool! Thanks!

I've been following the Jwillis72 saga.......or should I say soap opera. I feel his pain.

__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!

swiss370Z

Thanks to EVO

Attached Images

Vortech_Pulley_V1.jpg (172.4 KB, 176 views)

__________________
/// ONE LAST RIDE /// R.I.P. FAIRLADY Z ///

swiss370Z

I'll order the following items from Vortech:

2A038-347 8-Rib Supercharger Pulley (3.47") jack side

and

2A038-300 8-Rib High-Traction Supercharger Pulley (3.00 ") supercharger side

I will Report......(in April.....)

Thanks for the Info Guys

__________________
/// ONE LAST RIDE /// R.I.P. FAIRLADY Z ///

StillenZ84

I ordered the same pulleys and the original bolts to bolt them in are too short for the new pulleys. Anyone have experience with this and what did you have to do for them to fit right? Another thing I noticed was if you do replace one the other must be replaced also as it sticks out 1/4" further than the other which would make the belt not flush on both pulleys.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34