Carbon Fiber B pillars ready to order!

SpawnAeroJohn · 07-13-2009, 10:01 PM

Here are some successful pics! These just need a little cleaning, sanding on the sides and clear coat (these will be display models)

Again the first official set is reserved for bullitt which will be created tomorrow.

Any orders after that will be created during the creating of some front bumper license plate backings that were already ordered. We only took so long because we were looking for the right resin that can withstand the heat of the sun. Looks like we got it

Here are some pics.

In the mold

Out the mold

The back 100% carbon fiber and epoxy resin.

At the scale they weigh 1 oz each. Yours will weigh 1.2 - 1.5 oz each. (16 oz in a lb)

And the two together before final sanding and clear coating.

Quality guarantee! These can be direct replacements or overlays. Will come with enough 3M tape to take care of the whole job + a little extra for those who need to do everything twice before getting it right :P.

P.S You cant tell with out the clear coat but the body line that the original ones have going vertically will also be there.

PM to order!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Carbon Fiber Rims	armensti	Wheels & Tires	41	03-14-2013 12:21 PM
Carbon fiber stuff	SpawnAeroJohn	Exterior & Interior	47	07-26-2011 12:01 PM
Carbon fiber doors	SpawnAeroJohn	Exterior & Interior	19	06-26-2009 05:41 PM
Carbon Fiber Fenders	SpawnAeroJohn	Exterior & Interior	20	06-16-2009 08:42 PM
looking for 370z for carbon fiber project and free carbon fiber products	370z_hot	Exterior & Interior	23	05-16-2009 09:32 PM

07-13-2009, 10:01 PM	#1 (permalink)
SpawnAeroJohn NOT A CURRENT VENDOR Join Date: Jun 2009 Location: Chicago Posts: 609 Drives: you Rep Power: 19	Here are some successful pics! These just need a little cleaning, sanding on the sides and clear coat (these will be display models) Again the first official set is reserved for bullitt which will be created tomorrow. Any orders after that will be created during the creating of some front bumper license plate backings that were already ordered. We only took so long because we were looking for the right resin that can withstand the heat of the sun. Looks like we got it Here are some pics. In the mold Out the mold The back 100% carbon fiber and epoxy resin. At the scale they weigh 1 oz each. Yours will weigh 1.2 - 1.5 oz each. (16 oz in a lb) And the two together before final sanding and clear coating. Quality guarantee! These can be direct replacements or overlays. Will come with enough 3M tape to take care of the whole job + a little extra for those who need to do everything twice before getting it right :P. P.S You cant tell with out the clear coat but the body line that the original ones have going vertically will also be there. PM to order!