|
if there are no pre-drilled screw holes, just drill new holes. on my Ings, i made 3 holes in the center section and using the 2 holes on the sides
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-30-2012, 10:41 AM
|
#4 (permalink) |
|
A True Z Fanatic
 Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141522   |
if there are no pre-drilled screw holes, just drill new holes. on my Ings, i made 3 holes in the center section and using the 2 holes on the sides where it was pre-drilled.
put your car on ramps and you will see that it's very easy to do. you can source screws at acehardware. get bolts, locking nuts, and washers. still use the mounting tape as it will close up any gap and use the nuts/bolts to fasten to the bumper tightly. the torque should be snug, but dont over tighten. GL! |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: STILLEN 370Z Front Splitter Install | TypeOne | DIY Section (Do-It-Yourself) | 37 | 01-25-2014 03:37 PM |
| Kinetix Front Camber Arms Install | pokeyl | Brakes & Suspension | 16 | 10-16-2012 02:26 PM |
| Is there a DIY for front SPC Camber arms install? | TMAN1985 | Brakes & Suspension | 9 | 02-27-2012 04:23 AM |
| Front bumper foglight install | MY1STZ | Exterior & Interior | 3 | 09-12-2010 09:02 AM |
1Likes
Threaded Mode
