ClearMask Paint Protection (Clear Bra) Installation

HTP AutoWorks · 09-16-2010, 05:08 PM

Just a heads up. ClearMask is VentureShield film. I used to install their film and know the owner Jim very well. They are pretty good guys down there but I have been just buying ventureShield Ultra straight out as opposed to going through them. Looks like you did a good job on your install. I can tell from looking that you used a little too much soap in your slip solution... the water should still be clear. Also to seal your edges down the best way to do it is by using a heat gun... or a hair dryer will work also. Simply pressing the edges down while the car is warm is not hot enough to properly seal them. I can tell you that if you dont heat it with a hairdryer that within 6 months the edges will be lifting and you will have a very visible dirt line under the film. White is a must for heat sealing... trust me on this. So before you go much longer take the car in and heat the edges then press them down with a hard card. That will save you in the long run.

By the way I was in the Air Force 15 years and got out two years ago to do clear braas full time. I was a 1C6 while I was in. Always good to see another Air Force member on the forums. If you ever have any questions about your clear bra please let me know. I will be happy to help you out.

Thom

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What do people think of Clear Bra Paint Protection?	rbratton	Nissan 370Z General Discussions	304	01-18-2013 03:31 PM
Paint protection (clear bra) on 40th, with lots of pictures	Xan	Exterior & Interior	17	01-19-2011 10:39 AM
Auto Guard Paint Protection. What's the deal?	spearfish25	Nissan 370Z General Discussions	20	08-22-2010 03:41 PM
DFW Paint Protection install	hfrog355	Exterior & Interior	3	04-22-2010 10:11 PM
What does everyone use?? Ming paint protection or X pack or just zaino (please help)	MYZ34	Detailing / Washing / Waxing / Cosmetic Maintenance and Repair	80	10-11-2009 03:31 AM

09-16-2010, 05:08 PM	#12 (permalink)
HTP AutoWorks Banned Join Date: Jan 2009 Location: DFW Posts: 124 Drives: G35, Jeep SRT-8 Rep Power: 0	Just a heads up. ClearMask is VentureShield film. I used to install their film and know the owner Jim very well. They are pretty good guys down there but I have been just buying ventureShield Ultra straight out as opposed to going through them. Looks like you did a good job on your install. I can tell from looking that you used a little too much soap in your slip solution... the water should still be clear. Also to seal your edges down the best way to do it is by using a heat gun... or a hair dryer will work also. Simply pressing the edges down while the car is warm is not hot enough to properly seal them. I can tell you that if you dont heat it with a hairdryer that within 6 months the edges will be lifting and you will have a very visible dirt line under the film. White is a must for heat sealing... trust me on this. So before you go much longer take the car in and heat the edges then press them down with a hard card. That will save you in the long run. By the way I was in the Air Force 15 years and got out two years ago to do clear braas full time. I was a 1C6 while I was in. Always good to see another Air Force member on the forums. If you ever have any questions about your clear bra please let me know. I will be happy to help you out. Thom