Inconsistent shifts and more! Need help!

Spooler · 09-15-2014, 08:55 PM

Quote:

Originally Posted by JCA92

Like I said once I suck up the fluid, the particles mix in with the fluid and you can't see them anymore. Like MJB said, it's just dirt and debris that made its way past the seal.

Everyone is pointing towards the csc, but my pedal feel hasn't changed.

LOL, I just change it all. To me your just making clean dirty fluid if you just suck it out of the reservoir. .02cts free of charge...

JCA92 · 09-16-2014, 09:17 PM

Quote:

Originally Posted by Spooler

LOL, I just change it all. To me your just making clean dirty fluid if you just suck it out of the reservoir. .02cts free of charge...

Yeah I know, but I figured some fresh fluid is better than none. I dont have access to the proper equipment that is needed to flush the system out, which is why I just clean and top off the reservoir.

Spooler · 09-16-2014, 11:48 PM

Quote:

Originally Posted by JCA92

Yeah I know, but I figured some fresh fluid is better than none. I dont have access to the proper equipment that is needed to flush the system out, which is why I just clean and top off the reservoir.

You only need a floor jack, jack stand for safety, and a vaccum pump brake bleeder. Suck all the fluid out of the reservoir, add new fluid, Get under car on drivers side, hook up vaccum pump, crack open bleed screw ( 6mm I think), pump until the fill bottle is about 1/4 full, check fluid, pump some more, check fluid, empty old fluid canister, repeat until you get clean fluid. Piece of cake.

MJB · 09-17-2014, 12:49 AM

Quote:

Originally Posted by Spooler

You only need a floor jack, jack stand for safety, and a vaccum pump brake bleeder. Suck all the fluid out of the reservoir, add new fluid, Get under car on drivers side, hook up vaccum pump, crack open bleed screw ( 6mm I think), pump until the fill bottle is about 1/4 full, check fluid, pump some more, check fluid, empty old fluid canister, repeat until you get clean fluid. Piece of cake.

I'm not sure why, but the FSM says not to use a vacuum pump on the hydraulic system. I've always bled it the way Joe@Zspeed recommends (gravity bleed)

Spooler · 09-17-2014, 11:41 AM

Quote:

Originally Posted by MJB

I'm not sure why, but the FSM says not to use a vacuum pump on the hydraulic system. I've always bled it the way Joe@Zspeed recommends (gravity bleed)

It is a hand held vaccum pump. I see no issues with that. Now an electric one, oh yeah, it's just too much. I wouldn't use that.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Squeaking shifts?!?! Help	CERBERUSlucid	Engine & Drivetrain	24	02-22-2017 05:02 PM
Loud shifts from 1st gear to 2nd	The Z monster	Engine & Drivetrain	18	03-06-2012 04:44 PM
Smoother shifts while redlining?	wdkwang	Nissan 370Z General Discussions	25	02-21-2012 04:45 PM
brake light comes on during shifts	blacksheep	Nissan 370Z General Discussions	7	10-02-2010 06:37 PM
7AT: Does driving in manual mode change the way automatic shifts?	dandg	Nissan 370Z General Discussions	2	02-13-2009 01:28 PM