08-07-2015, 02:41 PM
|
#11 (permalink)
|
|
Track Member
Join Date: Apr 2013
Location: Huntsville, AL
Posts: 832
Drives: 2019 GT-R
Rep Power: 20169
|
Quote:
Originally Posted by Ryan @ RJM
Also TBatt made a good point about setting the AFP to zero for doing a full bleed. This is needed to push the highest volume of fluid thru the system and to ensure the MC goes full stroke to get all the air out of it. There is one exception here though - you only need to do this if you have air in the system you need to get out. Such as when you've had the system opened up to replace something. If just doing a simple clutch fluid flush for maintenance with one person pumping the pedal and another opening/closing the bleed screw then you don't need to adjust AFP first since there shouldn't be any trapped air you need out.
That note Is mostly just for guys or shops who installed the pedal along with a new clutch, CSC, clutch line or MC at the same time which is quite common.
|
Ryan, I'm glad you pointed the cruise control switch adjustment out. From what you are saying it looks like when I adjusted my switch I may have set it incorrectly. While I was trying to flush the clutch fluid I could not get any flow through the system until I set the AFP to zero. Then it pumped the fluid like it was supposed to. Back when I did my first test drive the cruise control would not engage so I set the switch so that the rubber pad was touching the metal part of the switch which may have been a little too much. I'll go back through the switch adjustment again.
Thanks for your helpful advise! 
|
|
|
Similar Threads
107Likes
Threaded Mode
