|
That looks like its either loose or to tight Reinstall it and don't over tighten the fitting that bolts the plate to the block, And make sure both surfaces are
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-27-2012, 06:01 PM
|
#3 (permalink) |
|
Administrator
Join Date: May 2009
Location: Disneyland, Ca
Posts: 8,736
Drives: 🔰
Rep Power: 10   |
That looks like its either loose or to tight
Reinstall it and don't over tighten the fitting that bolts the plate to the block, And make sure both surfaces are clean. I know its bloody mess! I had the same issue once. I just reinstalled and tightend just enough that it was snug and have not had any issues since. edit: Never mind just saw you did that 
__________________
  Last edited by Trips; 05-27-2012 at 06:16 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air leak | LafitteZ | Forced Induction | 1 | 01-31-2012 08:26 PM |
| Oil Leak | Oscar135 | Engine & Drivetrain | 6 | 09-26-2011 09:17 AM |
| Greddy oil cooler core help needed | zuperman 370 | Nissan 370Z General Discussions | 1 | 06-28-2011 07:08 AM |
| how to seal fittings of oil cooler? (urgent answer needed) | Pharmacist | Nissan 370Z General Discussions | 8 | 07-29-2010 08:46 PM |
| Doing an HPDE (level 1) @ Sebring, Oil Cooler needed? | flashburn | Track / Autocross / Drifting / Dragstrip | 24 | 04-04-2010 09:56 PM |
4Likes
Threaded Mode
