Code U1024 after going back to stock tune?

SonicVQ · 05-11-2021, 06:12 PM

Quote:

Originally Posted by tchertel

Everytime I flash my car with UpRev I get a U1024 and a U1000 that sits in the Permanent Codes for a few months and then goes away on their own. I was told this happens because UpRev disconnects these items from the network when it is uploading a tune to the ECU.

This is exactly correct!!

While the ECU was being flashed, it didn't have time to communicate with the VVEL module on the dedicated CAN bus or other modules on the other CAN bus and these code are set.

Every CAN bus module (ECU, TCM, BCM, M&A, IPDM/ER, etc) needs to have constant communication to and from every other CAN bus module. If more than 2 seconds go by WITHOUT communication (like when flashing an ECU) a CAN bus code is declared.

It can not be cleared by a scan tool, as it is a "Permanent" code. BUT after the required drive cycles, it will be cleared by the ECU once it has confirmed communication is good.

It is normal and nothing to worry about

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Anyone seen this code? U1024,VVEL CAN communication	COSMO	Forced Induction	30	07-26-2019 10:22 PM
Error code U1024	Stino	Tuning	9	07-28-2018 06:58 AM
Trouble code U1024	john26jm	Tuning	2	02-22-2015 08:30 PM
How to go back to stock tune?	Myron_Nismo	Tuning	6	03-22-2013 12:56 PM
Code U1024	Megan370z	Tuning	9	03-15-2010 08:15 PM