Link to the ss lines?

Sent from my LM-Q730 using Tapatalk

I got my ss hose from Jegs along with the AN fittings. The hose and fittings will cost more than the catch cans.

Does the "an" matter? How long of hoses do i need?. A link would work best, jegs website doesnt seem to work for me. Thanks.

Sent from my LM-Q730 using Tapatalk

If you want to use braided stainless hose. You should use the AN fittings. I don't know what size your cans are. On mine, I use -8 hose.

https://www.jegs.com/i/Vibrant-Perfo...18418/10002/-1

I got the same amazon cans as Mlsully. I was hoping to find the same or similar hoses and fittings

Sent from my LM-Q730 using Tapatalk

I don't know what the thread size is in the can. If it's like mine. I have to dig through some papers later tonight.

https://www.amazon.com/dp/B06XJTV45H?ref=yo_pop_ma_swf

Sent from my LM-Q730 using Tapatalk

I had to log into Jegs to find my old order. Here's what I used.

4 of these. These go into the cans.
https://www.jegs.com/i/Earls/361/AT9919EFJERL/10002/-1

10ft length
https://www.jegs.com/i/Earls/361/310008/10002/-1

2 of these. These go on the valve covers.
https://www.jegs.com/i/Fragola-Perfo...80208/10002/-1

4 of these.
https://www.jegs.com/i/Earls/361/AT800108/10002/-1

very helpful thank you. 4 hoses right?

Sent from my LM-Q730 using Tapatalk

One 10ft hose. You have to cut it to length you need for each section.

Have you ever worked with braided hose?

No first time


Sent from my LM-Q730 using Tapatalk

The braided hoses don't flex real good. You can't make sharp bends with it. To cut the hose. It's best to tape up the spot with lots of electrical tape. Then cut in the middle of the tape with a cut-off wheel on a die grinder. Don't use a hack saw. You'll tear it up.

You will need this to assemble the hose and fitting together.

https://www.jegs.com/i/JEGS/555/28010/10002/-1

Another thing to keep in mind with SS braided hose - be careful how they are routed and what they might be touching. As things vibrate and the motor rocks under torque, a SS braided hose laying against a soft rubber hose will eventually start wearing a hole into the rubber hose.


I went with silicone hoses for my cans.