Condenser connection

morice13

I am in dying need of getting a clear picture of the two connector on the right side of the radiator, one connector goes to the hood latch and rhe second one goes to the condensor dryer, this car was in an accident and these connectors got smashed, need to joint the cables but the colors are different, any help will be appreciated, could send me a pic 7322136158

morice13

All i need is to match the colors on the wires. Between the condensor dryer pigtail and the car hardness.

SouthArk370Z

The FSM has wiring diagrams, pinouts, wire colors, &c.

__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub
Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma

morice13

thanks for trying to help, but what I can find is that it only list the colors up to the connector that snaps to the pigtail in the pressure sensor, but it does not state to what colors it matches to.

SouthArk370Z

If it's a switch (I think you are talking about a pressure switch), then there is no polarity - wire it up either way and it will work.

__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub
Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma

morice13

Yes but it has three wires going to it Violet, Blue, beige. I have identify that the beige is the +5volts, the blue is signal to the ecm and the violet is the ground. The problem is that this cables connect to a pigtail that goes to the pressure sensor which the colors change to red, black and blue. Need to match them

SouthArk370Z

Get an ohmmeter. Should be zero ohms between one of the switch wires and ground - infinite ohms between other wires and ground. Other wires should swap between zero and infinite ohms as the switch makes/breaks.

__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub
Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma