DIY: Interior LED Color Change

DIGItonium

1) Pry map light covers. On each corner of the roof switch assembly, there are 4 prongs to pry.


2) Once the center piece has been removed. Pry and unlatch the LED module on each side.


3) This is the exposed LED assembly. Pry the back end and sides to remove the harness cover, then pry the ends to remove the cover for the LED.


4) Here is the exposed LED circuit with diode and 750 ohm resistor. You can change the resistor value to a lower value to increase LED brightness, but I decided to leave it alone.


5) The LED is wedged into the friction terminals, and it is easily removable by tugging on it.


6) The new LED 3mm round with diffused lens (milky white). The LED output color is white.


7) Here it is fully assembled and operational (with my Luxeon LED map lights).

Attached Images

	00.jpg (194.2 KB, 3737 views)
	01.jpg (183.4 KB, 3645 views)
	02.jpg (161.6 KB, 3632 views)
	03.jpg (170.2 KB, 3618 views)
	04.jpg (151.7 KB, 3617 views)
	05.jpg (227.9 KB, 3609 views)
	06.jpg (101.0 KB, 3610 views)

__________________

isayimandrew

For people with the Bose package, the bluetooth mic is located in the top left corner. You just have to pry the left and right side a little to take the bluetooth mic off from the panel.