DIY Yaw Sensor rocker switch

cossie1600 · 01-21-2019, 09:31 PM

So that green wire is a pain in the *** to get to. Would it seem smart to insert two posi tap to the wire at both ends, then extend the wire to an on off switch. After that, just cut the wire in between the two posi tap?

cossie1600 · 01-30-2019, 03:45 AM

Quote:

Originally Posted by cossie1600

So that green wire is a pain in the *** to get to. Would it seem smart to insert two posi tap to the wire at both ends, then extend the wire to an on off switch. After that, just cut the wire in between the two posi tap?

It’s alive

Just zip ties the rest of the wire to stick the green one out, insert the posi tap and go to town with it. Once everything is secure, cut the green wire and you are good to go

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Yaw sensor switch	dimitarm	Exterior & Interior	33	08-09-2017 11:13 PM
YAW Sensor Rocker Switch	dP3NGU1N	DIY Section (Do-It-Yourself)	23	11-10-2013 06:57 PM
Viper Security System/Tilt sensor/Proximity sensor	kfull	Nissan 370Z General Discussions	4	04-27-2012 01:10 AM
Installed the Rocker Stripe (pic)	kent370	Member's 370Z Gallery	9	02-15-2012 04:30 PM
Rocker panel chips?	JGreenwood07	Exterior & Interior	2	07-14-2010 11:58 AM

01-21-2019, 09:31 PM	#1 (permalink)
cossie1600 A True Z Fanatic Join Date: Jun 2009 Location: californee way Posts: 5,380 Drives: 370, Leaf Rep Power: 32	So that green wire is a pain in the *** to get to. Would it seem smart to insert two posi tap to the wire at both ends, then extend the wire to an on off switch. After that, just cut the wire in between the two posi tap?