DIY: How To Blackout/Plasti-dip Handles

NickTurnon

FOR THE ADVANCED: ORG. 08AWSTI
*NOTE: This can be done while the handles are still on the car! Disassembly is not needed.

1) MEASURE OUT CARBON FIBER WRAP TO INNER HANDLE
2) CUT WRAP WITH SHARP TOOL
3) PEEL BACKING OFF WRAP & HEAT AND APPLY TO INNER HANDLE.
4) REMOVE BAD EDGES WITH SHARP TOOL (XACTO KNIFE WORKS GREAT)
5) ONCE WRAP IS ON INNER HANDLE, TAKE HEAT GUN AND GO OVER THE ENTIRE HANDLE
6) MAKE SURE HANDLE IS CLEAN, TAPE OFF THE INNER HANDLE PORTION YOU JUST WRAPPED & YOU WILL BE PLASTI-DIPPING OVER.
7) TAPE OFF ENTIRE HANDLE AREA AS SEEN IN MY VIDEO ABOVE.
8) SPRAY ENTIRE HANDLE
9) WHEN DRY, PEEL OFF EXCESS PLASTI-DIP & DIP ON INNER HANDLE.
10) RUB EXCESS OFF PAINT WITH FINGERS

__________________
2009 Brilliant Silver BASE 7AT | TEIN S-Tech Springs | K&N Drop Ins & z1 Maf Tubes | AAM S-Line Short Tails | 5% Tint | 20MM Spacers | Sport Spoiler NickTurnon's 370z Build