|
Just drill two new holes in the bracket, higher, (up with the holes, down with the bracket), about 3/4" from the top. Flatten the mounting screws with sander or grinder,
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
07-10-2014, 12:14 PM
|
#37 (permalink) |
|
Track Member
 
Join Date: Oct 2012
Location: SE Texas
Posts: 556
Drives: 2014 Black Cherry Co
Rep Power: 15  |
New Holes in Bracket
Just drill two new holes in the bracket, higher, (up with the holes, down with the bracket), about 3/4" from the top. Flatten the mounting screws with sander or grinder, leaving enough of the Phillips slots to fasten it. Fasten it to the original places in the black facia. Mount plate. Now the entire assembly is below the painted area of the bumper.
DO NOT let the dealer mount your plates! The instructions say drill two large holes in the painted bumper. 10mm I think. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| License Plate Bracket Damaging Our Cars? | TheWeatherman | Exterior & Interior | 18 | 05-10-2013 08:22 PM |
| DIY: Power Retractable Front License Plate Install | ENT-Z | DIY Section (Do-It-Yourself) | 36 | 09-27-2012 02:20 AM |
| Please put your front license plate on | AK370Z | North East Region | 36 | 08-24-2009 02:30 PM |
| Installed front license plate bracket | AK370Z | Exterior & Interior | 25 | 07-12-2009 12:01 PM |
| Front Plate Bracket | CantZme | Exterior & Interior | 4 | 04-20-2009 08:52 PM |
1Likes
Threaded Mode
