DIY: GTR Red Start-Stop Button Swap out

FairladyZ · 04-25-2012, 05:14 AM

I read through this whole thing but wanted to be sure before I start.

I only have like 200 miles new car.

Anyways for 6 speed where do I pry with my screw driver? I'm gonna wrap it with tape then pry at the silver bezel correct? But can someone give me a specific location on the bezel? Also do I remove the bezel below that one? The black one it sits on?

chevytrucker · 04-26-2012, 01:18 PM

Quote:

Originally Posted by FairladyZ

I read through this whole thing but wanted to be sure before I start.

I only have like 200 miles new car.

Anyways for 6 speed where do I pry with my screw driver? I'm gonna wrap it with tape then pry at the silver bezel correct? But can someone give me a specific location on the bezel? Also do I remove the bezel below that one? The black one it sits on?

I've done 2 on the 7AT cars now and I was able to just pop off that bezel with my hands. I don't know if the manual one is harder to pull off. When I did it the first time, it didn't really start to make sense until I started pulling things off, then I could see in front of me where everything was and had it done in 5 minutes. I can't imagine the MT would be much harder, but it is possible. I would say just start pulling things apart, and be careful.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ridiculous start/stop button question...	KillerBee370	Nissan 370Z General Discussions	53	07-26-2012 08:42 AM
Alternate Method for GTR Red Start-Stop Button Swap	Zmax	DIY Section (Do-It-Yourself)	9	03-24-2012 09:26 AM
[FOR SALE] GTR Start/Stop Button	chuckd05	Parts for sale (Private Classifieds)	17	09-13-2011 06:46 AM
GTR start stop button	Reaper42	Exterior & Interior	24	09-12-2010 01:09 AM
Start-Stop Button swap out	Minicobra1	Exterior & Interior	53	05-04-2010 03:19 AM

04-25-2012, 05:14 AM	#1 (permalink)
FairladyZ Track Member Join Date: Jan 2009 Location: Los Angeles Posts: 850 Drives: 2012 370Z TRNG SPRT Rep Power: 19	I read through this whole thing but wanted to be sure before I start. I only have like 200 miles new car. Anyways for 6 speed where do I pry with my screw driver? I'm gonna wrap it with tape then pry at the silver bezel correct? But can someone give me a specific location on the bezel? Also do I remove the bezel below that one? The black one it sits on?