DIY: [How-To:] Racing Seat airbag light fix

CJBinder

First I already had my connectors done up and heat wrapped. I then put the leads on the exposed wire from resistor to heat wrapped. The reading was .8-.9. Granted I had already tried testing both connectors with resistors plugged in and the original weight sensor plugged into its connector. I also went thru the reset procedure. I also tried using the leads within the connector and same reading .8-.9 So maybe these blew?


I tested with just the resistor, new one out of package and put one lead on each side and was reading 5.5. How else do you test them?

I ordered some new ones. These were a bit more expensive as they were 4$ for 10 as last ones were like 4$ for 100.

__________________
Injen cold air intakes, Ported upper and lower manifolds, OS Giken LSD, F1 Long Tube Headers, Magnaflow CBE. Natural Baby

gomer_110

Testing just the resistor you did fine.

Problem is that once the resistor is soldered to the connector you will no longer get a proper reading due to the connector. There is something about the connector that makes it read as shorted (0 ohms). This in parallel with your resistor is causing you to read .8-.9 ohms.

__________________
'11 370Z Nismo #528 Fast Intentions | Stillen | Motordyne | Uprev | CSF | Zspeed | Z1 Motorsports | AST | Swift | SPC | SPL | Whiteline | Hotchkis | Bride | Schroth | Robispec | Cusco | Nismo | Volk | Forgestar | Hoosier | RJM
'17 Titan Bone Stock