Adjusting front spc camber arm

Alexwallace23 · 03-25-2014, 10:26 PM

Disconnecting the arm from the spindle will lower the arm down to where I could get a tool on the adjustment nut. I was hoping someone had a way to do it without doing this. Its going to make it harder for me to find a shop that will attempt the alignment if the arm has to be separated from the spindle to make the adjustments.

Quote:

Originally Posted by synolimit

So once installed you guys can't losen or tighten the top nut? Have you taken one endlink off yet? I'd imagine pop the wheel off, disconnect the arm from the spindle so the arm can swing down, then adjust and put it back together. A shops rack should be easy to do this with the jack that's under the car attached to the lift.

synolimit · 03-25-2014, 10:38 PM

Quote:

Originally Posted by Alexwallace23

Disconnecting the arm from the spindle will lower the arm down to where I could get a tool on the adjustment nut. I was hoping someone had a way to do it without doing this. Its going to make it harder for me to find a shop that will attempt the alignment if the arm has to be separated from the spindle to make the adjustments.

Many have lifetime adjustments. Can't see them giving you a problem.

Best to just mod the arm.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FOR SALE] KW Variant 3, SPC front/rear camber arms, Hotchkis front/rear sways	OMGWTFBBQ	Parts for sale (Private Classifieds)	11	04-14-2014 11:06 PM
WTB: Front Camber and Toe Kit	SilverBullet	Wanted	2	09-21-2013 11:17 AM
[FOR SALE] Spc front camber kit	blackonorange	Parts for sale (Private Classifieds)	2	11-28-2012 10:10 AM
[FOR SALE] SPC Front Camber Kit	W.O.W. 370Z	Parts for sale (Private Classifieds)	12	08-19-2012 08:28 PM
Front Camber vs. Rear Camber	osbornsm	Brakes & Suspension	2	02-21-2012 04:12 PM