Braking problem - malfunctioning ABS

ResIpsa · 05-10-2010, 11:17 AM

Quote:

Originally Posted by travisjb

That sounds good.

The expensive fluid won't lower temps as you know, but will have a higher b.p. So, you still may have an ABS sensor that gets excessively hot, and as you say, you will only be able to rule out fluid boiling as an individual cause.

Where are you pointing the air if not at the inside of the rotors? How far away is the outlet? Perhaps if you can point them towards the ABS sensor we can test the theory of sensor overheating as a cause.

The other one we need to test is differential wheel spin...

The ducts are pointing (as best I could) to directly under the brake caliper. I connected the end of the tubing to the lower part of the shock absorber. I would guess about 4 to 6 inches from the rotor. The main problem is the shape of our front spindle. It really blocks access to the inside of the rotor. In hindsight, I should have cut off the entire dust shield but I don't have a proper sheet metal shear (and I was getting tired).

I should have taken some pictures but I was not all that anxious to display my ghetto-cooling ducts. And it did take some cutting of the inside fender cover...

Keep in mind that I was retrofitting my fang ram air setup and this limited the length of my brake tubing.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
does everyone have this problem?	mattkim85	Nissan 370Z General Discussions	43	11-14-2009 08:37 PM
Problem after some Audio Upgrades	209Z	Audio & Video	1	06-13-2009 01:16 PM
Is there or is there not a problem with the oil cooler?	sluggoZ	Nissan 370Z General Discussions	26	03-18-2009 12:28 PM
First Drive = One Problem	dedede	Nissan 370Z General Discussions	14	12-31-2008 08:13 PM
First potential problem?	xDIEGOx	Nissan 370Z General Discussions	26	12-15-2008 11:30 AM