|
With OEM struts and swift springs I could not put a finger between top of tire and fender, now I can put 4-fingers between, so were the old struts that
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-27-2021, 05:42 PM
|
#5 (permalink) |
|
Base Member
Join Date: Aug 2010
Location: Oregon
Posts: 64
Drives: mb mt
Rep Power: 16  |
With OEM struts and swift springs I could not put a finger between top of tire and fender, now I can put 4-fingers between, so were the old struts that shot,
did I tighten things up incorrectly, or is the spring installed wrong, after installing top hat on the bench I could only get a few threads screwed on, after lowering car on the ground and driving a couple miles, I removed strut brace and was able to tighten the the nut on the top of the strut down more. Does not make any weird sounds when driving but something is not right, when re-attaching top mount in the wheel well (the bolt that goes thru the grove on the top swing arm piece) I had to pull down on it quite a bit to reach. thank you any comments to help, |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| noob koni question | Jmatchley86 | Brakes & Suspension | 0 | 09-21-2019 04:37 PM |
| Koni shock question | Jmatchley86 | Brakes & Suspension | 8 | 09-03-2019 10:40 AM |
| &&&& - Koni Shock/Strut super sale!! - &&&& | Kyle(Houston) | Suspension/Brakes | 202 | 09-02-2015 11:32 AM |
| Hood strut-shock install | MY1STZ | Exterior & Interior | 10 | 09-09-2013 06:24 PM |
| Rear Strut Question | Pensun | Brakes & Suspension | 1 | 02-04-2011 04:54 PM |
8Likes
Threaded Mode
