Bigaudiofanatic's Special

Originally Posted by bigaudiofanat

I wouldn't recommend keeping stock tweeters in weather your doing a component or coaxial speaker setup. Run all new wires and replace the stock tweeter and woofer at the same time, and be sure to use the crossover that is provided.

You can do a few different things to get the new tweeter in place. Hard sheet of plastic is one, cut out the old factory tweeter and use the stock bracket to hold the new tweeter is another.

Originally Posted by XwChriswX

Oh, no non no bud! Sorry, I should have worded that better. I would be replacing the stock tweeter with the new tweeter when I get my components, and using their crossover and new wiring of course. I was just curious about the new tweeters location, if I should put it back in the stock location, or move it to the door and have a co-ax setup.

Originally Posted by XwChriswX

Oh, no non no bud! Sorry, I should have worded that better. I would be replacing the stock tweeter with the new tweeter when I get my components, and using their crossover and new wiring of course. I was just curious about the new tweeters location, if I should put it back in the stock location, or move it to the door and have a co-ax setup.