Best area for amp

roplusbee · 01-13-2012, 06:06 PM

Quote:

Originally Posted by bigaudiofanat

I have put one there, just have to remove the foam piece.

What did you use to secure it in the area where the foam piece used to be? I have been playing around with options in that area. I cut up a styrofoam lid and used that as a temp base to see how it fit and if it would move around. It worked out well, I just need to get some sort of mounting hardware worked out. Did you cover it or just leave it open under the hatch cover?

37Z · 01-14-2012, 08:09 AM

Quote:

Originally Posted by roplusbee

What did you use to secure it in the area where the foam piece used to be? I have been playing around with options in that area. I cut up a styrofoam lid and used that as a temp base to see how it fit and if it would move around. It worked out well, I just need to get some sort of mounting hardware worked out. Did you cover it or just leave it open under the hatch cover?

I'm not sure of the amp you have; but typically styrofoam next to heat sinks on an amp is not good for the amp. Make sure the heat sinks are properly vented so the amp does not go into protection mode.

Their are 2 large blots that come up through the floor in the "foam piece" area of the hatch. Alternatively, you can add a nut to the large bolt that comes up through the floor to bolt down the amp rack. I just dynamat in the amp rack so it can not move. My amp rack and sub box covers the foam piece. I will add pics later.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Who is in the DC area?	blue660r01	The Lounge (Off Topic)	4	09-08-2011 10:02 PM
Hello from the SF Bay Area	TrackRat	New 370Z Owner	3	07-26-2010 02:47 PM
Where in the Area are you?	fullmonty	North East Region	2	06-24-2010 02:54 PM
From the bay area	Rockstar	New 370Z Owner	12	04-10-2009 01:00 AM
Hello from the DC area	Darkness	Introduction	6	01-04-2009 04:37 PM