|
The connector is two pieces, the first is the pressure lever that you pull down and pull out in between the door and the body of the car. The second
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-23-2011, 06:08 PM
|
#12 (permalink) |
|
Car Audio Installer
 
Join Date: Jun 2009
Location: Magnolia DE
Posts: 8,342
Drives: 2012 Infiniti G37x
Rep Power: 852     |
The connector is two pieces, the first is the pressure lever that you pull down and pull out in between the door and the body of the car. The second look at the other part of the harness between the door and the car frame and push up on the bottom of that piece of the harness. This will free it and allow you to push it into an area where you can pull it down and cut the plastic spacing out and run your wire.
Before cutting  After cutting  The lever part 
__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/ Last edited by bigaudiofanat; 09-23-2011 at 06:11 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Polk db6501 help! | Astrosfan | Audio & Video | 4 | 08-03-2011 09:56 AM |
| Component Speakers - Where does the Crossover go?? | Fatalsports | Audio & Video | 7 | 05-05-2011 01:42 AM |
| Polk DB6501 Question | Dubro | Audio & Video | 41 | 09-16-2010 11:58 PM |
| Polk db6501 and spacers? | F1loco | Audio & Video | 24 | 07-24-2010 10:51 PM |
| Polk MM6501 or Kenwood KFCP708 6 3/4 Component Speakers? | DarkZ | Audio & Video | 6 | 05-12-2010 06:52 PM |
Threaded Mode
