Stealth Bazooka install plus powdercoated rear brace bar

m4a1mustang

I think the brace comes out pretty easily. You just need to remove some of the interior panels to access the bolts.

__________________
- Steve

Zs & Coffee - Saturdays at 10AM in Fairfax, VA and Columbia, MD (Click the banner!)
LIKE us on Facebook!

Mike

You need to remove pretty much all of the interior panels except the quarter panel trim to get it out, then its just a matter of unbolting it.

If I had to do it again, I would move the 'Z' logo up a little. I centered it vertically between the two flat ribbed sides of the bar, but didn't realize the bar was actually slanted a little when installed, so its a little low, but still ok.

__________________
NISSAN: 75 280Z / 86 300ZX GLL /87 Sentra SE / 03 350Z / 23 Z
Porsche: 93 968 / 23 Macan GTS / 93 968