Metra Axxess Wiring

chemi19 · 11-06-2010, 10:54 AM

I can't seem to find clear instructions on how to wire the Metra Axxess ASWC for my new Kenwood radio. I am stuck on where to connect the Gray/Red & Gray/Blue. The instructions say to wire them to PIN 6 & 15 but on my metra wiring harness those seem to be designated for the left rear speakers.
Can anyone please help me decipher where those two wires should go?

As of right now my wiring is as follows:
ASWC-------- Radio Wiring Harness------KENWOOD
RED----------------RED
BLACK-------------GROUND
GRAY/RED---------?????
GRAY/BLUE--------?????
BROWN------------------------------------BROWN/YELLOW

TreeSemdyZee · 11-06-2010, 12:45 PM

This might help. This is the 370 specific instructions.

https://files.me.com/brianpmurphy/ybqvx5

chemi19 · 11-06-2010, 09:19 PM

Does that mean I have to tap into the vehicles wiring harness?

bigaudiofanat · 11-06-2010, 09:32 PM

Yes it does the blue and gray goes to a blue wire and the pink and gray goes to a pink wire. Best way is to cut them off the harness.

chemi19 · 11-07-2010, 10:59 PM

Ok... tried it and it didn't work. I dont know what I am doing wrong, but I found (I think) the pink wire (PIN 6)
PIN 15 which everyone describes as blue was black, connected that one to gray/blue.
PIN 16 which the manual says to wire to ground, did not exist on my harness.
Any ideas?
I had to put the car back together as its my DD. but I will be working on it again next weekend. Hopefully you guys can help me figure it by then

bigaudiofanat · 11-08-2010, 10:16 AM

Ground wire on the harness gets cut and grounded to metal

chemi19 · 11-08-2010, 10:58 AM

But which cable is the ground wire?
Its calling for pin 15 but there is no cable on pin 15 of the vehicles wiring harness

TreeSemdyZee · 11-08-2010, 05:27 PM

I didn't pay attention to the doc that I linked you to. I had already done the SWI-JACK unit before I did the Metra. Metra's pin arrangement is wrong.
Here's the link to the SWI which should match your wire setup.

http://www.pac-audio.com/swixprogram...ehicles&ID=417

On the '10, 16 is gray and 15 is black and 6 is white.

chemi19 · 11-08-2010, 09:33 PM

Thank you very much...
I will try that this weekend

11-06-2010, 10:54 AM	#1 (permalink)
chemi19 Base Member Join Date: Oct 2010 Location: Florida Posts: 38 Drives: 2010 370Z PG M6 Rep Power: 15	Metra Axxess Wiring I can't seem to find clear instructions on how to wire the Metra Axxess ASWC for my new Kenwood radio. I am stuck on where to connect the Gray/Red & Gray/Blue. The instructions say to wire them to PIN 6 & 15 but on my metra wiring harness those seem to be designated for the left rear speakers. Can anyone please help me decipher where those two wires should go? As of right now my wiring is as follows: ASWC-------- Radio Wiring Harness------KENWOOD RED----------------RED BLACK-------------GROUND GRAY/RED---------????? GRAY/BLUE--------????? BROWN------------------------------------BROWN/YELLOW

11-06-2010, 09:32 PM	#4 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	Yes it does the blue and gray goes to a blue wire and the pink and gray goes to a pink wire. Best way is to cut them off the harness. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

11-08-2010, 10:16 AM	#6 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	Ground wire on the harness gets cut and grounded to metal __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

11-08-2010, 05:27 PM	#8 (permalink)
TreeSemdyZee Premium Member Join Date: Dec 2009 Location: Kentuck-IANA Age: 61 Posts: 4,887 Drives: '09 370 & ‘14 Juke Rep Power: 27409	I didn't pay attention to the doc that I linked you to. I had already done the SWI-JACK unit before I did the Metra. Metra's pin arrangement is wrong. Here's the link to the SWI which should match your wire setup. http://www.pac-audio.com/swixprogram...ehicles&ID=417 On the '10, 16 is gray and 15 is black and 6 is white. Last edited by TreeSemdyZee; 11-08-2010 at 05:30 PM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Axxess ASWC wiring.	Z33knight	Audio & Video	16	12-19-2019 11:54 AM
Get the Axxess ASWC working - All buttons	Unclemeaty	Audio & Video	108	04-08-2019 05:32 PM
axxess module.	jayl	Mid-Atlantic Region	6	07-30-2012 10:23 AM
Metra Wiring Harness	chemi19	Audio & Video	2	11-05-2010 10:38 PM
metra axxess aswc not working	jayl	Audio & Video	8	06-26-2010 11:50 PM

11-06-2010, 12:45 PM	#2 (permalink)
TreeSemdyZee Premium Member Join Date: Dec 2009 Location: Kentuck-IANA Age: 61 Posts: 4,887 Drives: '09 370 & ‘14 Juke Rep Power: 27409	This might help. This is the 370 specific instructions. https://files.me.com/brianpmurphy/ybqvx5

11-06-2010, 09:19 PM	#3 (permalink)
chemi19 Base Member Join Date: Oct 2010 Location: Florida Posts: 38 Drives: 2010 370Z PG M6 Rep Power: 15	Does that mean I have to tap into the vehicles wiring harness?

11-07-2010, 10:59 PM	#5 (permalink)
chemi19 Base Member Join Date: Oct 2010 Location: Florida Posts: 38 Drives: 2010 370Z PG M6 Rep Power: 15	Ok... tried it and it didn't work. I dont know what I am doing wrong, but I found (I think) the pink wire (PIN 6) PIN 15 which everyone describes as blue was black, connected that one to gray/blue. PIN 16 which the manual says to wire to ground, did not exist on my harness. Any ideas? I had to put the car back together as its my DD. but I will be working on it again next weekend. Hopefully you guys can help me figure it by then

11-08-2010, 10:58 AM	#7 (permalink)
chemi19 Base Member Join Date: Oct 2010 Location: Florida Posts: 38 Drives: 2010 370Z PG M6 Rep Power: 15	But which cable is the ground wire? Its calling for pin 15 but there is no cable on pin 15 of the vehicles wiring harness

11-08-2010, 09:33 PM	#9 (permalink)
chemi19 Base Member Join Date: Oct 2010 Location: Florida Posts: 38 Drives: 2010 370Z PG M6 Rep Power: 15	Thank you very much... I will try that this weekend