PAC SWI-JACK kit wiring & programming is impossible, SOS

TreeSemdyZee · 06-07-2010, 11:39 PM

I won't be much help, but I had the PAC and hated it with a passion. I just installed a Metra ASWC and it is fabulous. No delay in response time and it autoprograms also.

The white wire from the SWI-JACK will connect to both resistors. These two resistors then connect to the pink and blue wires in the car.
•Pin 16 (blue wire) uses 150 ohm resistor.
•Pin 6 (Pink) uses a 47 ohm resistors.
•Pin 15 (black) is grounded.
DO NOT cut the loops.
Black wire to ground, red wire to switched power.

ON the other side, connect the yellow and green/blue(can't remember which) to the remote wire on the Kenwood. You won't use the plug for your Kenwood.Tape it up.

They are 1/4 watt. Per PAC, 1/2 watt will work.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Keyless Entry Programming	mannyz	Exterior & Interior	10	06-08-2011 01:07 PM
Window won't come up due to programming?	RedNismo	Nissan 370Z General Discussions	2	03-03-2010 01:05 AM
Programming / adding a FOB?	kannibul	Nissan 370Z General Discussions	7	10-28-2009 06:42 PM
Impossible to find base black/black auto + sport...	Portlis	Nissan 370Z Pricing / Ordering Discussions	10	06-13-2009 01:45 PM
Driver's Republic - Mission Impossible 370Z vs Porsche Cayman S 04.09.09	MannyLJr	Nissan 370Z General Discussions	11	04-10-2009 07:53 PM

06-07-2010, 11:39 PM	#10 (permalink)
TreeSemdyZee Premium Member Join Date: Dec 2009 Location: Kentuck-IANA Age: 62 Posts: 4,888 Drives: '09 370 & ‘14 Juke Rep Power: 27410	I won't be much help, but I had the PAC and hated it with a passion. I just installed a Metra ASWC and it is fabulous. No delay in response time and it autoprograms also. The white wire from the SWI-JACK will connect to both resistors. These two resistors then connect to the pink and blue wires in the car. •Pin 16 (blue wire) uses 150 ohm resistor. •Pin 6 (Pink) uses a 47 ohm resistors. •Pin 15 (black) is grounded. DO NOT cut the loops. Black wire to ground, red wire to switched power. ON the other side, connect the yellow and green/blue(can't remember which) to the remote wire on the Kenwood. You won't use the plug for your Kenwood.Tape it up. They are 1/4 watt. Per PAC, 1/2 watt will work.