I am thinking of buying an amp; Suggestions?

white37014

Not trying to hijack the thread but how about an amp for two front component speakers and one single sub in the rear not so much the exact amp but how many channels? I was looking at a 3 channel any thoughts?

TNBXIII

So, I was looking at some amps and I was thinking of getting the Rockford Fosgate Punch P300X2.

I think I was able to match the amp to my speakers based on what I read online. Could anybody confirm if this amp is good enough for my speakers? I do not want to overpower them.

Amp specs:
RMS Power Output (Watts x Channels) 100 x 2
Peak Power Output (Watts x Channels) N/A
Power at 2 Ohms (Watts x Channels) 150 x 2
Bridged Power (Watts x Channels) 300 x 1
Minimum Impedance Bridged 4
Minimum Impedance Unbridged 2
Best Frequency Response 20-20k Hz
THD at Rated RMS Power 1%
Signal to Noise Ratio 85 dB
Input Voltage

RonRizz

That amp will do just fine

__________________
P99rs Head Unit--- Amps- 2 Pioneer Prs800d --- Zapco ST1000MX---Zapco ST-4XSQ---- SI BM mk5 Subs---SI TM65v2 Midbass--- SI M3 mids--- SI M25 xbl2 tweeters ----- 2016 MECA street class 3rd place at world finals

RonRizz

or you could do a 4 channel, and bridge the 2 rear channels to your sub, or run a dual voice coil sub.

__________________
P99rs Head Unit--- Amps- 2 Pioneer Prs800d --- Zapco ST1000MX---Zapco ST-4XSQ---- SI BM mk5 Subs---SI TM65v2 Midbass--- SI M3 mids--- SI M25 xbl2 tweeters ----- 2016 MECA street class 3rd place at world finals