Advice for speaker/sub/amp selection

Equinox · 10-16-2009, 02:06 PM

And the one peice of advice killed five small children in a third world country.

I've always wanted to run aftermarket speaker wire to all my speakers, I'm sure I would be able to tell the difference.

Also, please type through Big, not threw, JEEZ. lol <3

bigaudiofanat · 10-16-2009, 02:17 PM

???

bigaudiofanat · 10-16-2009, 03:08 PM

Okay good deal than. LOL Ya that stock alt can dish out some pretty good power. I always put a optima yellow top battery in if I am serious about my audio system.

teejnut · 10-16-2009, 04:14 PM

Again thanks all for the advice/tips! I already ordered my zenclosure and speaker spacers. Now just getting the rest of the items in order.

For the sub since I'm going to be running a single sub at 4ohm I want the IDQ12V2.D2, right? I checked the wiring diagrams but just want to confirm.

bigaudiofanat · 10-16-2009, 04:16 PM

No the D4 you want a dual voice coil 4 ohms sub. The D2 is if you were going to run it at 1 ohms which not all the amps can run at that. so D4 what you want.

teejnut · 10-16-2009, 04:40 PM

Really? I want the run the single sub at 4ohm to my amp, correct?

I looked at this and I thought I would want a D2. http://www.imagedynamicsusa.com/pdf/...2%20WIRING.pdf

Here's the diagram for D4. http://www.imagedynamicsusa.com/pdf/...4%20WIRING.pdf

bigaudiofanat · 10-16-2009, 04:53 PM

It is a DUAL voice coil which means it can be wired as a 8 ohms or 2 ohm load. You are looking at the Single voice coils. Here is the diagram you should be looking at. And here is the sub

http://www.woofersetc.com/p6225/IDQ1...-Subwoofer.htm

teejnut · 10-16-2009, 05:17 PM

So with what you're saying I'm going to end up with a 2ohm load to my amp. With the JL G4500 and ch3/4 bridge it says minimum 4ohm. So then I would want the dual voice coil 2 ohm sub, right?

And even if I ran an amp the supported 2ohm since the Focal's are 4ohm don't I have to run all the speakers as 4ohm to the amp?

And the link I sent were for the DVC... says dual on both of those pdf's.

bigaudiofanat · 10-16-2009, 05:33 PM

Well I never knew which amp you were going with. So if you are going with the JL than you want the DVC 2 ohms and the speakers will be fine they are 4 ohms.

teejnut · 10-16-2009, 05:37 PM

Quote:

Originally Posted by bigaudiofanat

Well I never knew which amp you were going with. So if you are going with the JL than you want the DVC 2 ohms and the speakers will be fine they are 4 ohms.

Thanks for the help! So If I run the Alpine MRP-F600 then I would want the DVC 4ohms since the amp can handle the 2ohm load.

bigaudiofanat · 10-16-2009, 05:49 PM

Correct

blackbird · 10-16-2009, 06:36 PM

I see suggestions for the Door speakers but what about the "tweeters" on the top of the dash?

bigaudiofanat · 10-16-2009, 06:38 PM

ANY "component" SET includes tweeters so the speakers that were recommended includes tweeters.

blackbird · 10-16-2009, 06:43 PM

OK, thanks. I've done upgrades on cars but never audio gear.

teejnut · 10-19-2009, 12:18 AM

If I want to use the OEM speaker wiring I would just run speaker wiring from the crossover to the FR/FL wiring on the harness, right? The stock base doesn't have an amp that I have to bypass or anything?

10-16-2009, 02:06 PM	#1 (permalink)
Equinox Track Member Join Date: Jul 2009 Location: Beaumont, TX Posts: 685 Drives: 06 Porsche Carrera S Rep Power: 19	And the one peice of advice killed five small children in a third world country. I've always wanted to run aftermarket speaker wire to all my speakers, I'm sure I would be able to tell the difference. Also, please type through Big, not threw, JEEZ. lol <3 __________________ Check out my Albums '13 Subaru WRX STi \| '06 Porsche 911 Carrera S (SOLD) \| '96 Mazda RX-7 6.0L V8 RHD (SOLD) \| '09 Nissan Nismo #0058 (SOLD)

10-16-2009, 02:17 PM	#2 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	??? __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

10-16-2009, 03:08 PM	#3 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	Okay good deal than. LOL Ya that stock alt can dish out some pretty good power. I always put a optima yellow top battery in if I am serious about my audio system. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

10-16-2009, 04:16 PM	#5 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	No the D4 you want a dual voice coil 4 ohms sub. The D2 is if you were going to run it at 1 ohms which not all the amps can run at that. so D4 what you want. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

10-16-2009, 04:53 PM	#7 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	It is a DUAL voice coil which means it can be wired as a 8 ohms or 2 ohm load. You are looking at the Single voice coils. Here is the diagram you should be looking at. And here is the sub http://www.woofersetc.com/p6225/IDQ1...-Subwoofer.htm __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/ Last edited by bigaudiofanat; 10-16-2009 at 04:56 PM.

10-16-2009, 04:14 PM	#4 (permalink)
teejnut Base Member Join Date: Sep 2009 Location: Burbank, CA Posts: 206 Drives: 09 Z34 Sport/6MT Rep Power: 17	Again thanks all for the advice/tips! I already ordered my zenclosure and speaker spacers. Now just getting the rest of the items in order. For the sub since I'm going to be running a single sub at 4ohm I want the IDQ12V2.D2, right? I checked the wiring diagrams but just want to confirm.

10-16-2009, 04:40 PM	#6 (permalink)
teejnut Base Member Join Date: Sep 2009 Location: Burbank, CA Posts: 206 Drives: 09 Z34 Sport/6MT Rep Power: 17	Really? I want the run the single sub at 4ohm to my amp, correct? I looked at this and I thought I would want a D2. http://www.imagedynamicsusa.com/pdf/...2%20WIRING.pdf Here's the diagram for D4. http://www.imagedynamicsusa.com/pdf/...4%20WIRING.pdf

10-16-2009, 05:17 PM	#8 (permalink)
teejnut Base Member Join Date: Sep 2009 Location: Burbank, CA Posts: 206 Drives: 09 Z34 Sport/6MT Rep Power: 17	So with what you're saying I'm going to end up with a 2ohm load to my amp. With the JL G4500 and ch3/4 bridge it says minimum 4ohm. So then I would want the dual voice coil 2 ohm sub, right? And even if I ran an amp the supported 2ohm since the Focal's are 4ohm don't I have to run all the speakers as 4ohm to the amp? And the link I sent were for the DVC... says dual on both of those pdf's.

10-16-2009, 05:33 PM	#9 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	Well I never knew which amp you were going with. So if you are going with the JL than you want the DVC 2 ohms and the speakers will be fine they are 4 ohms. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

10-16-2009, 05:49 PM	#11 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	Correct __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

10-16-2009, 06:36 PM	#12 (permalink)
blackbird Base Member Join Date: May 2009 Location: Nashua NH Posts: 179 Drives: 09 370Z BLk GTM TT Rep Power: 18	I see suggestions for the Door speakers but what about the "tweeters" on the top of the dash?

10-16-2009, 06:38 PM	#13 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 854	ANY "component" SET includes tweeters so the speakers that were recommended includes tweeters. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

10-16-2009, 06:43 PM	#14 (permalink)
blackbird Base Member Join Date: May 2009 Location: Nashua NH Posts: 179 Drives: 09 370Z BLk GTM TT Rep Power: 18	OK, thanks. I've done upgrades on cars but never audio gear.

10-19-2009, 12:18 AM	#15 (permalink)
teejnut Base Member Join Date: Sep 2009 Location: Burbank, CA Posts: 206 Drives: 09 Z34 Sport/6MT Rep Power: 17	If I want to use the OEM speaker wiring I would just run speaker wiring from the crossover to the FR/FL wiring on the harness, right? The stock base doesn't have an amp that I have to bypass or anything?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Speaker Spacers	Mike@ZE	ZEnclosures	22	01-28-2012 07:03 PM
Speaker Size	370book	Audio & Video	44	05-18-2010 10:42 PM
Speaker Wiring	bpd138	Audio & Video	24	09-04-2009 02:36 PM
Speaker/Amp Choices	MacDaddy	Audio & Video	4	07-06-2009 10:35 AM
Rear Speaker/Sub Box	zero610	Audio & Video	19	05-29-2009 07:27 AM