The "Will it fit?" thread

[jchammond]

Originally Posted by YzGyz

I have: 2010 Nismo stock height, stock suspension

I have a set of HR Pro 5 racing rims that I would like to put Drag radials on.

Spare rim brand: HR size 19/10 +44 offset
How wide and tall of a tire can I safely get on there? I have to drive 50 minute to and then 50 minutes from the track with them on.







Thanks in advance
YzGyz

Driving that far too & from the track...i'd bout only rely on Mickey Thompson Drag Radials.
The 19" choice is very slim (1) 27.90" tall
This will reduce your hole-shot,unless you have lower gears.
Should clear fine & tuck well underneath fender/ & i'm guessing you have already installed rear camber arms;to stand them upright?
Not sure how big your brakes are; but better selection in 18" & down.

[YzGyz]

Originally Posted by jchammond

Driving that far too & from the track...i'd bout only rely on Mickey Thompson Drag Radials.
The 19" choice is very slim (1) 27.90" tall
This will reduce your hole-shot,unless you have lower gears.
Should clear fine & tuck well underneath fender/ & i'm guessing you have already installed rear camber arms;to stand them upright?
Not sure how big your brakes are; but better selection in 18" & down.

Stock Akebono brakes. I have read that 18's will clear however, the HR are the rim I have in storage to use. As for the MT DR, can you clearify why you would choose them over Nittos?

No new camber arms or anything. Everything is stock other than the power adder and urethane rear dif bushings.

YzGyz

[jchammond]

Originally Posted by YzGyz

Stock Akebono brakes. I have read that 18's will clear however, the HR are the rim I have in storage to use. As for the MT DR, can you clearify why you would choose them over Nittos?

No new camber arms or anything. Everything is stock other than the power adder and urethane rear dif bushings.

YzGyz

Nitto's High Quality tire also; both will wear out the inner part of tire faster-unless camber is brought to "0" or ver close to it.
These cars negative camber when you launch-which may lead to a slight + initial camber setting,to get maximum rubber surface touching.
NT05R 305/35 should fit as well. 27.44" tall