By the way, when I told him that a couple of us were interested, he said he would give us a discount

Also, he said if there's anything custom or any changes you want made, he would do them.

I need to see a picture of how it integrates with the inner fender. My intakes and brake cooling ducts run through there and it is close.

Anyway we can use different bolts. Bolt heads hanging down look like chit. Anyway we can use some type of flush mount bolts? I will drag those bolts heads off to a nub. LOL

It does have brake duct openings. I don't know if they'll be a benefit to you

Those are not for brake ducts. Those are for air flow control under the car.

Check your Instgram messages, I sent you the pdf of their installation instructions with pics

According to their pdf instructions, they're for brake duct hoses

Now I see what you're talking about. They're to funnel air to the brakes, not for hoses. Doh :icon14:

After looking at the pictures on their website. I have to give this a :thumbsdown:

The reasons. It doesn't stick out far enough to be effective. It is angled up in the front increasing lift at speed. It still uses the black plastic piece under the bumper.

Did you remove your factory splitter?

The black piece piece under the very front of the bumper? Yea. I'm using the ZSpeed under tray too.

When the guy who's car is in the pictures comes in for the diffuser design, he will confirm it's level and not angled upward.

Yeah, it sucks too. I freaking hate that the middle was not keep flat. Too disruptive to airflow. I am thinking about going back to stock.

Thing for me is I don't want to buy somethings else that doesn't work as intended. I would rather spend more and have a quality piece that works.