Yep:bowrofl::icon18:

Too late...I already have the Stillen ceramic headers and gonna wrap them tomorrow for good measure.:rolleyes:

That looks low for a 2015 Nismo. It should be closer to the 300hp at the wheels.

Could be the type of dyno they used. It's not a dynojet.

Yeap, There is a used set in the Classifieds.

It was a dynodanamics...after i get the tune on it...I'm gonna get some better numbers from a dynojet hopefully

Went to the track last night, I just got my car back from the shop and I have installed a Motordyne upper intake manifold, Stillen Gen3 intakes, and the AAM R-Line 3" dual CBE, but haven't had time to put the headers, test pipes, transmission oil cooler, or lower intake manifold on. Without a tune and on the OEM bridgstone tires and ran 13.47@ 105mph. In the Louisiana heat

Why am I not in the 12s
 

I went to the track a few weeks ago after doing a tune and ran in similar weather to the previous post with a time of 13.39.
The Dyno shows the tune with 302whp for this run.

I added the Z1 ported lower intake manifold, Motordyne ART test pipes, Stillen headers, and another tune and went to the strip and ran a 13.12 in 90 degree heat (full bolt on). The Dyno now shows 312whp.

12 second car finally
 

I installed reflective heat tape on my intakes and did it. Went to the strip the other night and ran 12.83 @ 108mph...Its about time. Temp was right @ 77 degrees. FYI the paddle shifters work much better on the auto than just drive. In drive I ran consistent 13.04 then swapped to paddles and ran consistent 12.8s. In auto it seems that it hits redline and hesitates to shift costing a few tenths.

12 second car finally
 

I installed reflective heat tape on my intakes and did it. Went to the strip the other night and ran 12.83 @ 108mph...Its about time. Temp was right @ 77 degrees. FYI the paddle shifters work much better on the auto than just drive. In drive I ran consistent 13.04 then swapped to paddles and ran consistent 12.8s. In auto it seems that it hits redline and hesitates to shift costing a few tenths. I'll head back when temps get into the 60s and see where it's at.

Nice work keep it going.

Keeping it going
 

Today I ordered a set of forgestars wrapped in Nitto NT-05R 305/35/19. Hopefully I won't have to wait too long, I can't wait to see these on.

Wheels and tires
 

Getting some decent weather and my back wheels came in.
19x11 +15 wrapped in 305/35/19 Nitto NT05R. Soon I'll have a couple pics with them on to check the fitment.

Mounted
 

Rears on

You should have the 3.69 rear axle gearing,,,gotta heat them tires good & evenly;
should get in the 1.80's 60'.